Explosive Compaction of Chromium Carbide Powders with a Metallic Binder

Krokhalev, A. V.; Kharlamov, V. O.; Кузьмин, С. В.; Lysak, V. I.; Пай, В. В.

doi:10.1134/s0010508219040178

Cited by 10 publications

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The steel substrate improved the compacting pressure by reflecting the incident shock wave in the powder from the substrate surface. The physical parameters of compression implemented in the experiments were calculated by the method of (P, u) charts, by analyzing the intersections of the shock adiabates a b c of the substrate, powder, foundation and detonation products in the pressure -mass speed coordinates, using a specially developed program [6,7]. The powder heating temperature was calculated based on the inner energy increment values determined by the powder particle mass speed values [8].…”

Section: Methodsmentioning

confidence: 99%

Investigation of the Structure and Distribution of Chemical Elements between the Phases of Hard Alloys of the Cr3C2-Ti System, Obtained at Various Modes of Explosive Compaction

Kharlamov

Krokhalev

Кузьмин

et al. 2020

MSF

View full text Add to dashboard Cite

The Article presents the findings of the studies of the microstructure, chemical and phase composition of the Cr3C2-Ti system alloys obtained by the explosion. Scanning electron microscopy, energy dispersive and x-ray diffraction analyses were used. The program Thermo-Calc software was used to calculate the equilibrium phases. The phase composition of the compact was shown to fully correspond to that of the initial powder mixture during explosive pressing in the modes of heating from 300 ̊С to 600 ̊С. When heated above 600 ̊С, the chemical interaction of the initial components begins with the formation of new boundary phases. Meanwhile, there is a change in the sample destruction nature and a significant increase in hardness, which points to the hard alloy consolidation. The increase in the powder mixture heating in shock waves to 1000 ̊С leads to intensive macrochemical interaction of the powder mixture components and to formation of an equilibrium phase composition. The established temperature limits determine the most appropriate parameters of shock-wave loading when producing hard alloys by explosive pressing.

show abstract

Section: Methodsmentioning

confidence: 99%