Experimental investigation of the effect of processing parameters on densification, microstructure and hardness of selective laser melted 7075 aluminium alloy

Abstract

The 7075 aluminum alloy of the 7xxx series largely used for structures in modern aircraft has been successfully fabricated using selective laser melting (SLM) technology. The morphology of the initial 7075 aluminum alloy powders was characterized by a Zeiss Evo 50 Scanning electron microscope (SEM). Energy Dispersive x-ray (EDX) spectrometer attached to SEM was used as a tool to obtain the chemical composition of the powders. Processing parameters including scan speed, hatch distance and constant laser power (100 and 150 W) effect on densification, microstructure and hardness were investigated. The initial powder particles were found to be elongated and non-spherical and composed of Al, Zn, Mg, Cu, and Ag without Si. The result of the influence of processing parameters on properties of the as-built samples by SLM technology indicates that higher densification of parts can be gained using higher laser power and lower laser scan speed and hatch distance due to significant reduction in the number of pores. Two major types of pores including metallurgical and keyhole pores have been identified with the keyhole pores dominating the samples processed by low laser power of 100 W. The keyhole pores increase in size at a high scan speed and hatch distances. By using higher laser power of 150 W, the keyhole pores reduced significantly while metallurgical pores appear. The result of the hardness test conducted on the samples shows that high values of hardness can be achieved with low scan speed.

Laser melting deposition of aluminium 7050 alloy: Heat treatment, microstructure and mechanical properties

“…These cracks form due to the effect of notches initiated by the pores. Therefore, reducing the porosity may also reduce the initiation of cracks [17,20,27].…”