Experimental and theoretical analysis of CFRP reinforced concrete beam anchored by CF anchors

Zhuang, Ning; Ma, Yeming; Dong, Honghan; Chen, Da

doi:10.1088/1757-899x/191/1/012044

Cited by 1 publication

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…where ρ = E f t f b f /E c t c b c . Based on the calculation of the actual bonded joints in the existing single shear tests or strengthened members [16,19,[23][24][25], the value of ρ was generally less than 0.01. Therefore, the parameter ρ is temporarily assumed to be zero in the subsequent derivation due to its little influence on the interfacial bond behavior.…”

Section: Differential Equilibrium Equationsmentioning

confidence: 99%

See 1 more Smart Citation

Analytical Model for Bond Behavior Prediction of CFRP-Concrete Joints with End Anchorage

Dong

Zhong

2021

Polymers

View full text Add to dashboard Cite

Use of the end anchorages can significantly control the debonding of CFRP-to-concrete bond interface, and improve the bearing capacity of CFRP strengthened concrete member. An analytical model was presented in this paper to predict the bond behavior and debonding process of CFRP-concrete bonded joint with end anchorage. The calculation formulas of bond failure load and effective bond length for anchored CFRP-concrete joint are derived from the proposed analytical model. According to these models and formulas, the influence of different bond lengths on the mechanical behaviors during the debonding process was analyzed. Results show the load-slip curves of end anchored CFRP-concrete joints could be divided into three branches: elastic stage, stable stage, and enhancement stage. As the bond length increases, the plateau length in stable stage increases. Besides, the bond failure load decreased firstly to a lower limit and then increased with the increase of bond length. The effective bond length of CFRP-concrete joint with end anchorage was longer than that of the external bonded joint, and the value of effective bond length for end anchored joint shall be at least 7.2/AB, where the parameters A and B were related to the interfacial properties of bonded joint. Furthermore, a single shear test was carried out on the end anchored CFRP-concrete bonded joint with different bond lengths, to verify the consistency of the proposed model and formulas. The analytical result of load-slip response at the load end, as well as the strain distribution of CFRP material and the bond failure load, was compared with the experimental result. The comparisons showed that the analytical results had a good agreement with the experimental results.

show abstract

Section: Differential Equilibrium Equationsmentioning

confidence: 99%

“…The corresponding anchor force P a,d and bond force P b,d can be obtained by introducing Equation (25) into Equations ( 22) and (23). Figure 4 shows the evolution curves of P d , P a,d and P b,d along with the change of bond length.…”

Section: Bond Failure Loadmentioning

confidence: 99%

Analytical Model for Bond Behavior Prediction of CFRP-Concrete Joints with End Anchorage

Dong

Zhong

2021

Polymers

View full text Add to dashboard Cite

show abstract

Experimental and theoretical analysis of CFRP reinforced concrete beam anchored by CF anchors

Cited by 1 publication

References 5 publications

Analytical Model for Bond Behavior Prediction of CFRP-Concrete Joints with End Anchorage

Analytical Model for Bond Behavior Prediction of CFRP-Concrete Joints with End Anchorage

Contact Info

Product

Resources

About