Experimental and CFD Investigation of a Modified Uneven-Span Greenhouse Solar Dryer in No-Load Conditions under Natural Convection Mode

Abstract

An uneven-span modified greenhouse dryer was constructed and tested in no-load conditions under natural convection mode under the weather conditions of Marrakech, Morocco, for two distinct days. Moreover, a CFD evaluation of the uneven-span greenhouse dryer was performed as tool to visualize the air temperature distribution inside the dryer. For validating the CFD model, the temperature variations along the hours of the day were compared to the experimental results. A good agreement is obtained between the computed and measured inside air temperature with a difference not exceeding 8.46°C, with a correlation coefficient ( r ) and root mean square percentage deviations ( e ) 0.94 and 8.17, respectively. Furthermore, the maximum inside air temperature was measured to be 56°C and 52°C while the minimum inside relative humidity was measured to be 17% and 12%, for day-1 and day-2, respectively. The benefice of using asphalt as a floor covering material was revealed as an efficient way to heat the inside air at low solar radiations. The performances of the dryer were evaluated by the percentage of net heat gain variation as a way to validate the effectiveness of the dryer. This latter is found to be equal to 46% and 48% for the two days, respectively.

Thermal and CFD Analyses of Sustainable Heat Storage-Based Passive Greenhouse Dryer Operating in No-Load Condition

“…The governing equations considered in the present CFD analysis are based on the following Navier-Stokes equations [20,31,32]:…”

CFD simulation of a solar collector integrated with PCM thermal storage

“…Computational fluid dynamics (CFD) in a solar air heater for the drying application is drawing a lot of interest to examine how various parameters affect the drying process. Additionally, evaluating the temperature distribution and melting fraction during charging and discharging of PCM under various climatic conditions (irradiance, ambient temperature, and PCM properties) will aid to optimize the design of the air heater shape as well as the air treatment and conditioning system 15 . It is clear from the previous works that a through thermal model on an FPSC for air heating and drying application need to take into account the system's thermal behavior, interactions between its essential components, estimation of the PCM's liquid fraction over a period of time, and evaluation of the charging and discharging cycles of the PCM.…”

Thermal performance assessment of a passive mixed-mode solar dryer

“…The passive or natural convection mixed mode solar dryer performed better due to its mode and design (Mustayen, Mekhilef, & Saidur, 2014). Mellalou et al (2021) discussed how the convection methods of solar dryers can be either passive (natural) or active (forced) depending on the design. Passive dryers are more economical and cheaper as reported by (Balasuadhakar, Fisseha, Atenafu, & Bino, 2016).…”