Exoskeleton Recognition of Human Movement Intent Based on Surface Electromyographic Signals: Review

Self Cite

In this study, we design an embedded surface EMG acquisition device to conveniently collect human surface EMG signals, pursue more intelligent human–computer interactions in exoskeleton robots, and enable exoskeleton robots to synchronize with or even respond to user actions in advance. The device has the characteristics of low cost, miniaturization, and strong compatibility, and it can acquire eight-channel surface EMG signals in real time while retaining the possibility of expanding the channel. This paper introduces the design and function of the embedded EMG acquisition device in detail, which includes the use of wired transmission to adapt to complex electromagnetic environments, light signals to indicate signal strength, and an embedded processing chip to reduce signal noise and perform filtering. The test results show that the device can effectively collect the original EMG signal, which provides a scheme for improving the level of human–computer interactions and enhancing the robustness and intelligence of exoskeleton equipment. The development of this device provides a new possibility for the intellectualization of exoskeleton systems and reductions in their cost.

Section: Introductionmentioning

confidence: 99%

An Embedded Electromyogram Signal Acquisition Device

Lu,

Xu,

Liu

et al. 2024

Self Cite

Knee Angle Estimation from Surface EMG during Walking Using Attention-Based Deep Recurrent Neural Networks: Feasibility and Initial Demonstration in Cerebral Palsy

Abdelhady,

Damiano,

Bulea

2024

Accurately estimating knee joint angle during walking from surface electromyography (sEMG) signals can enable more natural control of wearable robotics like exoskeletons. However, challenges exist due to variability across individuals and sessions. This study evaluates an attention-based deep recurrent neural network combining gated recurrent units (GRUs) and an attention mechanism (AM) for knee angle estimation. Three experiments were conducted. First, the GRU-AM model was tested on four healthy adolescents, demonstrating improved estimation compared to GRU alone. A sensitivity analysis revealed that the key contributing muscles were the knee flexor and extensors, highlighting the ability of the AM to focus on the most salient inputs. Second, transfer learning was shown by pretraining the model on an open source dataset before additional training and testing on the four adolescents. Third, the model was progressively adapted over three sessions for one child with cerebral palsy (CP). The GRU-AM model demonstrated robust knee angle estimation across participants with healthy participants (mean RMSE 7 degrees) and participants with CP (RMSE 37 degrees). Further, estimation accuracy improved by 14 degrees on average across successive sessions of walking in the child with CP. These results demonstrate the feasibility of using attention-based deep networks for joint angle estimation in adolescents and clinical populations and support their further development for deployment in wearable robotics.

A Recurrent Deep Network for Gait Phase Identification from EMG Signals During Exoskeleton-Assisted Walking

Guerra,

Schmid,

Sozzi

et al. 2024

Lower limb exoskeletons represent a relevant tool for rehabilitating gait in patients with lower limb movement disorders. Partial assistance exoskeletons adaptively provide the joint torque needed, on top of that produced by the patient, for a correct and stable gait, helping the patient to recover an autonomous gait. Thus, the device needs to identify the different phases of the gait cycle to produce precisely timed commands that drive its joint motors appropriately. In this study, EMG signals have been used for gait phase detection considering that EMG activations lead limb kinematics by at least 120 ms. We propose a deep learning model based on bidirectional LSTM to identify stance and swing gait phases from EMG data. We built a dataset of EMG signals recorded at 1500 Hz from four muscles from the dominant leg in a population of 26 healthy subjects walking overground (WO) and walking on a treadmill (WT) using a lower limb exoskeleton. The data were labeled with the corresponding stance or swing gait phase based on limb kinematics provided by inertial motion sensors. The model was studied in three different scenarios, and we explored its generalization abilities and evaluated its applicability to the online processing of EMG data. The training was always conducted on 500-sample sequences from WO recordings of 23 subjects. Testing always involved WO and WT sequences from the remaining three subjects. First, the model was trained and tested on 500 Hz EMG data, obtaining an overall accuracy on the WO and WT test datasets of 92.43% and 91.16%, respectively. The simulation of online operation required 127 ms to preprocess and classify one sequence. Second, the trained model was evaluated against a test set built on 1500 Hz EMG data. The accuracies were lower, yet the processing times were 11 ms faster. Third, we partially retrained the model on a subset of the 1500 Hz training dataset, achieving 87.17% and 89.64% accuracy on the 1500 Hz WO and WT test sets, respectively. Overall, the proposed deep learning model appears to be a valuable candidate for entering the control pipeline of a lower limb rehabilitation exoskeleton in terms of both the achieved accuracy and processing times.