Evaluation of Virus Inactivation by Formaldehyde to Enhance Biosafety of Diagnostic Electron Microscopy

Abstract

Formaldehyde (FA) fixation of infectious samples is a well-established protocol in diagnostic electron microscopy of viruses. However, published experimental data that demonstrate virus inactivation by these fixation procedures are lacking. Usually, fixation is performed immediately before the sample preparation for microscopy. The fixation procedure should transform viruses in a non–infectious but nonetheless structurally intact form in order to allow a proper diagnosis based on morphology. FA provides an essential advantage in comparison to other disinfectants, because it preserves the ultrastructure of biological material without interfering significantly with the preparation (i.e., the negative staining) and the detection of viruses. To examine the efficiency of FA inactivation, we used Vaccinia virus, Human adenovirus and Murine norovirus as models and treated them with FA under various conditions. Critical parameters for the inactivation efficiency were the temperature, the duration of the FA treatment, and the resistance of the virus in question. Our results show that FA inactivation at low temperature (4 °C) bears a high risk of incomplete inactivation. Higher temperatures (25 °C) are more efficient, although they still require rather long incubation times to fully inactivate a complex and highly robust virus like Vaccinia. A protocol, which applied 2% buffered FA for 60 min and a temperature–shift from 25 to 37 °C after 30 min was efficient for the complete inactivation of all test viruses, and therefore has the potential to improve both biosafety and speed of diagnostic electron microscopy.

Inactivated or damaged? Comparing the effect of inactivation methods on influenza virions to optimize vaccine production

“…These methods vary with respect to the exact experimental conditions used, including concentration and incubation time. In some cases, incomplete inactivation is reported, mostly occurring when the inactivation was performed at low temperature [34], as was done in this study.…”

Tungsten carbide nanoparticles show a broad spectrum virucidal activity against enveloped and nonenveloped model viruses using a guideline‐standardized in vitro test

“…Another limitation of the suspension test is the high cytotoxicity of tested disinfectants when using assay conditions with relatively low initial virus titres. However, this impacted only the estimation of the RF values of formaldehyde, which is an acknowledged disinfectant (Möller et al ).…”

Test methods for estimating the efficacy of the fast-acting disinfectant peracetic acid on surfaces of personal protective equipment

“…Adenovirus was grown and titrated in A 546 cells (ATCC CCL‐185 TM ) cultivated in Eagle's minimal essential medium (EMEM) supplemented with 1% l ‐glutamine, 10% FCS, 1% non‐essential amino acids, 1% sodium pyruvate and 0·1% sodium hydrogen carbonate (Möller et al . ). For the determination of the virus titre 100 μ l of cell suspensions (1·0 × 10 5 cells ml −1 in EMEM containing 2% FCS) were filled into every well of a 96‐well microtitre plate.…”