Evaluation of Electrochemical Characteristics for Casted AC7AV Aluminum Alloy

Kim, Seong Jong; Park, Jae Cheul; Jang, Seok Ki

doi:10.4028/www.scientific.net/amr.811.54

Cited by 2 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…However, in the case of Paste 1, the current density diminishes over time. This reduction can be attributed to the potential decreasing over time, as per Ohm's law [11],…”

Section: B Electrochemical Analysis Of Sintered Samplesmentioning

confidence: 99%

Understanding Cu Sintering and Its Role on Corrosion Behaviour for High-Temperature Microelectronic Application

Kotadia,

Ahuir-Torres,

Bhogaraju

et al. 2024

IMAPSource Proceedings

View full text Add to dashboard Cite

There has been a significant rise in interest from academic and industry communities on copper nano and micro-particles-based sinter pastes for harsh environment die attach. However, sintering these particles is a complex process which is affected by many parameters, such as (i) particles size, shape, and distribution, (ii) sintering temperature, pressure, environment, and (iii) organic compounds used for the paste formulation. In literature, various research groups demonstrated that sintered copper layer can achieve good electrical conductivity and high strength. In our previous research [1, 2], we explained that microscale etched flakes are also capable of shear strength >30Mpa while sintering with 10 MPa bonding pressure at 275°C for just 1 minute with negligible paste cost (in comparison to silver paste). However, very limited knowledge exists on literature about corrosion behaviour in sintered copper interconnects. This, from experience in the industry with silver sintering has proven to be critical to applications. For examples in high power LED headlamp applications, minor exposure to residual Sulphur emerging from vulcanized rubber seals has been observed to cause corrosion in silver sintered interconnects. Therefore, corrosion and its impact on performance and reliability must be considered, especially for safety critical applications. For this reason, we have studied the relationship between copper sintered samples and corresponding corrosion behaviours and compared again to pure copper (conventionally produced). The corrosion resistance of the samples in salt water was assessed via various electrochemical analysis techniques and correlated with sintered microstructure. Sample produced better corrosion resistance when fabricated with higher density (less porosity). However, in case of the microscale copper flakes-based interconnects, a pitting behaviour was observed. The sintered copper paste samples showed to be nobler than commercial copper. In addition, copper oxide and its role in accelerating/preventing oxidation is also studied.

show abstract

“…However, in the case of Paste 1, the current density diminishes over time. This reduction can be attributed to the potential decreasing over time, as per Ohm's law [11],…”

Section: B Electrochemical Analysis Of Sintered Samplesmentioning

confidence: 99%