Evaluation of Co-MCM-41 Nanocatalyst for BTEXS Removal in Industrial Wastewater Samples by Headspace Coupled with Gas Chromatography

Heydari, Mohammad; Tabatabaie, Tayebeh; Amiri, Fazel; Hashemi, Seyed Enayat

doi:10.1007/s11270-023-06715-9

Cited by 3 publications

(2 citation statements)

References 83 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The temperature of the oven for thermal oil increased to 160 °C. On the Vent ON [47] Press OFF [46] Press ON [6] Probe ON [5] Press OFF [3] No EVENT [0]…”

Section: Analysis By Mhe Methodsmentioning

confidence: 99%

“…The validation analysis was carried out over the course of three days using the standards and sample repetitions as described. Based on prior research (45,46), a LOD/LOQ calculation was made. According to the formula LOD= 3.3 (Sy/S), the standard deviation and the calibration curve's slope of the output curve from the calculation, respectively, were used to determine the LOD (31,(47)(48)(49).…”

Section: Methods Validationmentioning

confidence: 99%

See 1 more Smart Citation

Multiple Headspace Extraction for Benzene and Toluene Quantitative Analysis in Hot Oils

Ghavidel,

Heydari

2024

IJEE

View full text Add to dashboard Cite

In this article, the concentration of some volatile organic compounds (VOCs) in the hot oil sample of the Pars petrochemical ethylbenzene unit is presented. Pars Petrochemical is one of the largest producers of ethylbenzene in the Middle East. The hot oil impurities that were analyzed were benzene and toluene (BT). The hot oil sample was taken in May 2023 at a special sampling station on the site. The presence of BT is related to its intensity in the hot oil sample. The Multiple Headspace Extraction (MHE) method was used for the extraction and quantitative analysis of BT followed by gas chromatography (GC) analysis. A GC with flame ionization detector (FID) instrument was used for the analysis of BT. This method offers advantages for the analysis of volatile pollutants because it eliminates the use of organic solvents and various sample purification steps that often lead to erroneous results. The MHE method is independent of standard concentration and could be used in a wide range of BT in Hot Oil without calibration for different ranges. Also, linearity, detection limits, and accuracy were looked into as part of the validation process. The limit of detection (LOD) and limit of quantification (LOQ), respectively, were between 0.05 -0.56, and 0.17 -1.9 mg/kg. Less than 13.95 percent (n= 15) was the relative standard deviation statistically. A quick and easy method for detecting BT in hot oil samples was used for the first time. This work will be a step forward for the detection of other aromatic and cyclic hydrocarbons in hot oil samples.

show abstract

“…The temperature of the oven for thermal oil increased to 160 °C. On the Vent ON [47] Press OFF [46] Press ON [6] Probe ON [5] Press OFF [3] No EVENT [0]…”

Section: Analysis By Mhe Methodsmentioning

confidence: 99%