Evaluation of Artifacts and Distortions of Titanium Applicators on 3.0-Tesla MRI: Feasibility of Titanium Applicators in MRI-Guided Brachytherapy for Gynecological Cancer

Self Cite

The objective of this work is to present commissioning procedures to clinically implement a three‐dimensional (3D), image‐based, treatment‐planning system (TPS) for high‐dose‐rate (HDR) brachytherapy (BT) for gynecological (GYN) cancer. The physical dimensions of the GYN applicators and their values in the virtual applicator library were varied by 0.4 mm of their nominal values. Reconstruction uncertainties of the titanium tandem and ovoids (T&O) were less than 0.4 mm on CT phantom studies and on average between 0.8‐1.0 mm on MRI when compared with X‐rays. In‐house software, HDRCalculator, was developed to check HDR plan parameters such as independently verifying active tandem or cylinder probe length and ovoid or cylinder size, source calibration and treatment date, and differences between average Point A dose and prescription dose. Dose‐volume histograms were validated using another independent TPS. Comprehensive procedures to commission volume optimization algorithms and process in 3D image‐based planning were presented. For the difference between line and volume optimizations, the average absolute differences as a percentage were 1.4% for total reference air KERMA (TRAK) and 1.1% for Point A dose. Volume optimization consistency tests between versions resulted in average absolute differences in 0.2% for TRAK and 0.9 s (0.2%) for total treatment time. The data revealed that the optimizer should run for at least 1 min in order to avoid more than 0.6% dwell time changes. For clinical GYN T&O cases, three different volume optimization techniques (graphical optimization, pure inverse planning, and hybrid inverse optimization) were investigated by comparing them against a conventional Point A technique. End‐to‐end testing was performed using a T&O phantom to ensure no errors or inconsistencies occurred from imaging through to planning and delivery. The proposed commissioning procedures provide a clinically safe implementation technique for 3D image‐based TPS for HDR BT for GYN cancer.PACS number(s): 87.55.D‐

Section: Methodsmentioning

confidence: 99%

Section: Methodsmentioning

confidence: 99%

Section: Methodsmentioning

confidence: 99%

Section: Methodsmentioning

confidence: 99%

Section: Methodsmentioning

confidence: 99%

See 3 more Smart Citations

Commissioning of a 3D image‐based treatment planning system for high‐dose‐rate brachytherapy of cervical cancer

Kim

Modrick

Pennington

et al. 2016

Self Cite

Patient's specific integration of OAR doses (D2 cc) from EBRT and 3D image‐guided brachytherapy for cervical cancer

Gelover

Katherine

Mart

et al. 2018

Self Cite

The objective of this study was to assess the recommended DVH parameter (e.g., D2 cc) addition method used for combining EBRT and HDR plans, against a reference dataset generated from an EQD2‐based DVH addition method. A revised DVH parameter addition method using EBRT DVH parameters derived from each patient's plan was proposed and also compared with the reference dataset. Thirty‐one biopsy‐proven cervical cancer patients who received EBRT and HDR brachytherapy were retrospectively analyzed. A parametrial and/or paraaortic EBRT boost were clinically performed on 13 patients. Ten IMRT and 21 3DCRT plans were determined. Two different HDR techniques for each HDR plan were analyzed. Overall D2 cc and D0.1 cc OAR doses in EQD2 were statistically analyzed for three different DVH parameter addition methods: a currently recommended method, a proposed revised method, and a reference DVH addition method. The overall D2 ccEQD 2 values for all rectum, bladder, and sigmoid for a conformal, volume optimization HDR plan generated using the current DVH parameter addition method were significantly underestimated on average −5 to −8% when compared to the values obtained from the reference DVH addition technique (P < 0.01). The revised DVH parameter addition method did not present statistical differences with the reference technique (P > 0.099). When PM boosts were considered, there was an even greater average underestimation of −8~−10% for overall OAR doses of conformal HDR plans when using the current DVH parameter addition technique as compared to the revised DVH parameter addition. No statistically significant differences were found between the 3DCRT and IMRT techniques (P > 0.3148). It is recommended that the overall D2 cc EBRT doses are obtained from each patient's EBRT plan.

Simple phantom fabrication for MRI‐based HDR brachytherapy applicator commissioning

Fagerstrom

Kaur²

2020

A new high dose rate (HDR) brachytherapy program was initiated in a community hospital setting, with the goal of using magnetic resonance (MR) images with the implant in place during the planning process. Physics acceptance testing and commissioning was completed for key program components, including multiple applicators. To image new applicators for MRI‐based planning prior to use with patients, agar gel doped with copper sulfate was created using simple, MR‐safe household materials as a practical and inexpensive alternative to custom‐machined precision phantoms. Applicators in‐phantom were scanned in a 1.5 T MRI scanner using the same sequences developed for the brachytherapy program, then rigidly registered to high‐resolution computed tomography (CT) images to assess distortion, artifact, and geometric displacement. To date, Varian tandem and ring sets, segmented cylinders, cervical probes, endometrial applicators; and third‐party plastic needles, tandems, and vaginal guides have been imaged in phantom and are available for use clinically.