Evaluation of an activated carbon packed bed for the adsorption of phenols from petroleum refinery wastewater

Abstract

The performance of an adsorption column packed with granular activated carbon was evaluated for the removal of phenols from refinery wastewater. The effects of phenol feed concentration (80-182 mg/l), feed flow rate (5-20 ml/min), and activated carbon packing mass (5-15 g) on the breakthrough characteristics of the adsorption system were determined. The continuous adsorption process was simulated using batch data and the parameters for a new empirical model were determined. Different dynamic models such as Adams-Bohart, Wolborsko, Thomas, and Yoon-Nelson models were also fitted to the experimental data for the sake of comparison. The empirical, Yoon-Nelson and Thomas models showed a high degree of fitting at different operation conditions, with the empirical model giving the best fit based on the Akaike information criterion (AIC). At an initial phenol concentration of 175 mg/l, packing mass of 10 g, a flow rate of 10 ml/min and a temperature of 25 °C, the SSE of the new empirical and Thomas models were identical (248.35) and very close to that of the Yoon-Nelson model (259.49). The values were significantly lower than that of the Adams-Bohart model, which was determined to be 19,358.48. The superiority of the new empirical model and the Thomas model was also confirmed from the values of the R and AIC, which were 0.99 and 38.3, respectively, compared to 0.92 and 86.2 for Adams-Bohart model.

Removal of methylene blue dye from aqueous solution by nonliving lichen (Pseudevernia furfuracea (L.) Zopf.), as a novel biosorbent

“…The fitting of experimental data to the kinetic models was determined by AIC (Wagenmakers and Farrell 2004;El-Naas et al 2017).…”

O Uso Da Experimentação Como Ferramenta Facilitadora Para O Ensino De Reação De Dupla Troca

“…O modelo analítico desenvolvido por Thomas considera que a taxa de adsorção é representada pela cinética de Langmuir. O modelo também leva em consideração um parâmetro muito importante para o processo de adsorção, que é a capacidade máxima de remoção de adsorbato pelo adsorvente (Thomas, 1944;El-Naas et al, 2017). O modelo de Thomas é representado pela Equação (6):…”

Batch and fixed-bed column studies for selective removal of cesium ions by compressible Prussian blue/polyurethane sponge

“…The Yoon-Nelson model is based on the assumption that the decrease in the probability of each adsorbate to be adsorbed is proportional to the probability of its adsorption and breakthrough on the adsorbent. 39 The Thomas model and Yoon-Nelson model can be expressed as the eqn (12) and (13), respectively.…”