Evaluation of 3C microelectromechanical system data on a 2D line: Direct comparison with conventional vertical-component geophone arrays and PS-wave analysis

Abstract

A 2D vibroseis line was acquired in the Vienna Basin (Austria) for the purpose of comparing the data of digital multicomponent single sensors based on microelectromechanical system (MEMS) sensors alongside conventional vertical-component geophone arrays. For efficient removal of coherent noise during processing, all source points were recorded in single-sweep mode, i.e., no vertical stacking was performed in the field. On this densely sampled data set, several noise-reduction techniques, such as digital array forming, frequency-wavenumber (f-k) filtering in shot and receiver domains, and polarization filters, proved to be valuable in reducing source-generated noise. The results showed that, with the use of single-sweep recording and polarization filter techniques, it is possible to produce seismic sections for a singlereceiver three-component (3C) MEMS line that are comparable to a conventional geophone array line in signal-to-noise ratio. However, the higher number of single geophones and hence the stronger attenuation of random noise in the conventional array resulted in an advantage for the analog geophone data set. The second goal for this survey was to evaluate additional information contained in the horizontal components of the MEMS data. The multicomponent data allowed for the processing of mode-converted shear-wave data, performed for the first time in the Vienna Basin. Azimuthal anisotropy related to horizontal stresses was observed in the Neogene section of the shear-wave data set. A PP-PS event correlation allowed the identification of major shallow horizons. Interpretation of the final sections confirmed that the PS data are useful to distinguish between gas reservoirs and high-porosity water sands, which can cause similar P-wave amplitude variation with offset (AVO) effects.

Research on Geophone Array Method and Forward and Inversion Algorithm in Micro-seismic Positioning and Monitoring System

“…However, there are few references regarding how the array affects the precision and the reliability of the system and optimization of the geophone array [7,8]. Therefore, an urgent research is needed on the subject [9][10][11][12]. Wang jian et al researched optimal design of geophone network in seismic monitoring.…”

High precision capacitance displacement measurement circuit design

“…Nowadays, precision machining technologyhas become an important index of the development of industry and science technology [1][2][3][4] .The ultra-precision measurement technology is always explored andgained more attention.The precision measurement technique is the key part of the measurement of machinery industry development in almost all developed countries.Capacitive displacement sensor technology is themost mainly used measurement method. This technology obtained more attention and has been applied in many different fields.…”