ESA's space solar array technology programme current status and future activities

Lisbona, Emilio Fernandez; Signorini, C.; Bogus, K.

doi:10.1016/s0927-0248(00)00210-5

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In concentrator setups, solar cells tend to become very hot; a thin film cell, which can be cooled more efficiently, is then an essential step towards higher concentration factors [5]. For space applications, where the weight of the solar cells is important, thin film cells with efficiencies comparable to cells on substrate are very desirable [6]. Finally, thin film solar cells show a much larger transparency for light with an energy that is smaller than the bandgap of the semiconductor material, compared to cells on their substrates.…”

Section: Introductionmentioning

confidence: 99%

Strain-accelerated HF etching of AlAs for epitaxial lift-off

Voncken¹,

Schermer

Bauhuis

et al. 2004

J. Phys.: Condens. Matter

View full text Add to dashboard Cite

Epitaxial lift-off (ELO) is a process which allows for the separation of a single crystalline III/V thin film or device from the substrate it was deposited on. This process is based on the selective etching of an intermediate AlAs release layer in an aqueous HF solution. The lateral etch rate of the AlAs release layer through a narrow crevice in the weight-induced epitaxial lift-off (WI-ELO) process is much larger than observed for unobstructed planar AlAs layers. It is possible that this increase in etch rate is caused by the tensile strain induced upon the AlAs layer in the WI-ELO setup. In order to verify this assumption, planar AlAs layers, subjected to a controlled curvature, were etched in HF solutions and their etch duration was measured. The applied curvature reduced the already present compressive strain due to lattice mismatch. For large applied bending radii no change in etch rate was observed, because the induced bending is smaller than the already present bending due to the lattice mismatch. Further bending induces a total compressive strain from −0.126% to −0.11%, resulting in an etch rate variation from 0.054 up to 0.066 mm h−1. Measurements on AlAs layers experiencing a tensile strain of +0.286% showed much higher etch rates of 0.134 mm h−1. The present results obtained on etching experiments in the lateral plane are extrapolated to the perpendicular direction so that a combination with the data from previous work becomes feasible. This results in a better microscopic picture of the etch front in the WI-ELO process. It is found that the force exerted by the weight can be projected on an area, limited by the sample width and a depth of approximately 6 µm.

show abstract

Section: Introductionmentioning

confidence: 99%