Enhancing the sensitivity and selectivity of pyrene-based sensors for detection of small gaseous molecules via destructive quantum interference

Sengul, Ozlem; Völkle, Julia; Valli, Angelo; Stadler, Robert

doi:10.1103/physrevb.105.165428

Cited by 2 publications

(1 citation statement)

References 76 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Materials like Semiconductor Metal Oxides (SMO) [15], carbon nanotubes [16], and polymers can sense a variety of gases based on variations in electrical properties. Sensitivity, selectivity, stability, fabrication cost, response time, recovery time etc; are the important parameters to be considered while evaluating the performance of a gas sensor [17,18]. Response or recovery time is the time takento reach 90% of the equilibrium values in electrical propertybaseline to 90% of the steady value.…”

Section: Introductionmentioning

confidence: 99%

Frequency dependent impedance response analysis of nanocrystalline ZnO chemiresistors

P V,

Tom,

Urs

et al. 2023

Nanotechnology

View full text Add to dashboard Cite

ZnO is a widely studied gas sensor material and is used in many commercial sensor devices. However, selectivity towards any particular gas remains an issue due to a lack of complete knowledge of the gas sensing mechanism of oxide surfaces. In this paper, we have studied the frequency dependent gas sensor response of ZnO nanoparticles of a diameter of nearly 30 nm. A small rise of synthesis temperature from 85 to 95oC in the solvothermal process, shows coarsening by joining and thereby distinct loss of grain boundaries as seen from transmission electron micrographs. This leads to a substantial reduction in impedance, Z (GΩ to MΩ), and rises in resonance frequency fres (from 1 to 10 Hz) at room temperature. From temperature dependent studies it is observed that the grain boundaries show a Correlated Barrier Hopping (CBH) mechanism of transport and the hopping range in the grain boundary region is typically 1 nm with a hopping energy of 153 meV. On the other hand, within the grain, it shows a change of transport type from low temperature tunneling to beyond 300oC as polaron hopping. The presence of disorder (defects) as the hopping sites. The temperature dependence of fres agrees with different predicted oxygen chemisorbed species between 200 to 400oC. As opposed to the traditional DC response, the AC response in the imaginary part of Z (Z′′) shows gas specific resonance frequencies for each gas, such as NO2, ethanol, and H2. Among the two reducing gases, ethanol and hydrogen; the former shows good dependence on concentration in Z′′ whereas the latter shows a good response in fres as well as capacitance. Thus, the results of frequency dependent response allow us to investigate greater details of the gas sensing mechanism in ZnO, which may be exploited for selective gas sensing.

show abstract