Enhancing Light Harvesting in Dye-Sensitized Solar Cells through Mesoporous Silica Nanoparticle-Mediated Diffuse Scattering Back Reflectors

Abstract

Dye-sensitized solar cells (DSSCs) hold unique promise in solar photovoltaics owing to their low-cost fabrication and high efficiency in ambient conditions. However, to improve their commercial viability, effective, and low-cost methods must be employed to enhance their light harvesting capabilities, and hence photovoltaic (PV) performance. Improving the absorption of incoming light is a critical strategy for maximizing solar cell efficiency while overcoming material limitations. Mesoporous silica nanoparticles (MSNs) were employed herein as a reflective layer on the back of transparent counter electrodes. Chemically synthesized MSNs were applied to DSSCs via bar coating as a facile fabrication step compatible with roll-to-roll manufacturing. The MSNs diffusely scatter the unused incident light transmitted through the DSSCs back into the photoactive layers, increasing the absorption of light by N719 dye molecules. This resulted in a 20% increase in power conversion efficiency (PCE), from 5.57% in a standard cell to 6.68% with the addition of MSNs. The improved performance is attributed to an increase in photon absorption which led to the generation of a higher number of charge carriers, thus increasing the current density in DSSCs. These results were corroborated with electrochemical impedance spectroscopy (EIS), which showed improved charge transport kinetics. The use of MSNs as reflectors proved to be an effective practical method for enhancing the performance of thin film solar cells. Due to silica’s abundance and biocompatibility, MSNs are an attractive material for meeting the low-cost and non-toxic requirements for commercially viable integrated PVs.

Size-Controlled Cu3VSe4 Nanocrystals as Cathode Material in Platinum-Free Dye-Sensitized Solar Cells

“…The DSSC device fabrication steps were adopted from our previous work; − the photoanodes and the counter electrodes were prepared separately, which were then assembled and followed by an insertion of I – / I 3 – electrolyte (60 μL) in between. The preparation steps for individual photoanodes and CEs are as follows:…”

Enhancing Efficiency in Dye-Sensitized Solar Cells: Incorporation of Cu3VSe4 Nanocrystals into TiO2 Photoanodes

“…Photoanodes were fabricated by following a multistep procedure reported in our work. , The FTO substrates were first patterned using a chemical etching procedure, which involved depositing zinc paste on the FTO layer and then etching it with an aqueous HCl (18.5% v/v) solution added dropwise. The substrates were then rinsed with nanopure water.…”

Use of deep eutectic solvents in environmentally-friendly dye-sensitized solar cells and their physicochemical properties: a brief review

“…153 In addition, the integration of nanostructures such as nanowires and nanoparticles can be employed to improve the capture and absorption of light. 154 Light harvesting can be made even more effective by using different sensitizers that have absorption spectra that work well with each other and by making the path length of photons longer inside the cell. 155 The calculated LHE for triad complexes using ZINDO/S method reported, 152 the highest value of oscillator strength (13.8) is related to the C60-P-NiP in 545.1 nm wavelengths while lowest value (0.46) belongs to the C60-P-TiP in 478.5 nm.…”