Enhancing ablation and oxidation resistance of phenolic resin with modified pickling asbestos

Abstract

Given the increasing requirements for ablative thermal protection materials, there is an urgent need for boron phenolic resin (BPR) composites with excellent high‐temperature strength properties as well as ablation performance to address the structural failure during the ablation process of these devices. Herein, modified pickling asbestos (MPA) was successfully incorporated into BPR to prepare MPA‐modified BPR (MPABPR). In addition, one‐dimensional MPA with improved dispersion and compatibility was used to fabricate a fiber‐reinforced network inside of BPR for the first time, which effectively increased the high‐temperature strength and ablation resistance of BPR. The results demonstrated that the high‐temperature strength of MPABPR was optimally improved by 25% compared to pure BPR. Meanwhile, when the content of MPA was only 5 wt%, the linear and mass ablation rates of MPABPR could reduce to 0.046 mm/s and 0.043 g/s, which were 34.3% and 23.2% lower than that of pure BPR, respectively. This study has the enormous potential to provide a new strategy for preparing high‐performance BPR matrix materials.Highlights The dispersion and compatibility of PA are improved by modification. MPA constructs a fiber‐reinforced network that can strengthen the carbon layer. The ablative properties of MPABPR have great advantages over the BPR. The compressive strength of carbonized MPABPR5 is 25% higher than that of BPR.