Enhancement of power quality using microprocessor based shunt active power filter for unbalanced load

Abstract

Power quality is the most significant factor of power sector. The end user equipment such as induction motor, inverters, rectifiers inject harmonics into power system that influences the quality of power delivered. The presence of harmonics forces the use of instantaneous reactive power theory to calculate instantaneous power that helps in finding the compensating currents to eliminate harmonics. The control action required by active filter is accomplished by STM32F303RET6 microcontroller. Single phase induction motor is used as a dynamic nonlinear load in one of the three phases and resistive loads on the other two phases. TRIAC based RC triggering circuit was used to control the single phase induction motor. This paper presents the simulation and hardware implementation of shunt active power filter for 3 phase 4 wire unbalanced system. The hardware results show that THD in the source side has been reduced from 50.7% to 9.6% by implementing the SAPF.

Study of the characteristics of broadband matching antennas for fifth-generation mobile communications based on new composite materials

“…Mechanisms for achieving low mutual coupling effects have been proposed in [7]- [9], but the designs of these studies require a distance between antenna pairs to maintain good isolation. In [10], a simple small-sized planar loop antenna with dimensions of 15×27 mm 2 is considered, which we will use as the antenna under study. This antenna includes tuning lines to achieve good impedance matching for the wireless wide area network/long-term evolution (WWAN/LTE) bands.…”

The performance of a multilevel multifunctional solar inverter under various control methods

“…The overall efficiency of any PV system is determined by its ability to extract reference current signals. Control techniques for grid-connected solar PV include Akagies instantaneous reactive power (IRP) theory [34]- [39], SRF theory [40]- [48], leaky least mean square (LMS) [49], and LMS-least mean fourth (hybrid LMS-LMF) [50]- [52]. All of these theories proposed different methods for obtaining reference currents.…”