Enhancement of Mixing Performance of Non-Newtonian Fluids using Curving and Grooving of Microchannels

Abstract

In this study, a numerical investigation was performed on the mixing of non-Newtonian power-law fluids in curved micromixers with power-law indices between 0.49 and 1 and Reynolds numbers between 0.1-300. The properties of water and CMC solution were used for simulation of Newtonian and non-Newtonian fluid flows, respectively. The effects of grooves embedded on the bottom wall of micromixers and geometrical parameters such as depth and angle of grooves on mixing performance were examined. The mixing of nonNewtonian fluids using this kind of micromixers has not been studied before. Eventually, using of inclined grooves with 30° inclination angle was studied. Open source CFD code of OpenFOAM was utilized to simulate the mixing process. The results showed that the grooves caused chaotic advection and improved the mixing performance but had no significant effect on dimensionless pressure drop. Also, the grooves with 30• angle showed better mixing index for all values of power-law indices.

Optimization of an Active Electrokinetic Micromixer Based on the Number and Arrangement of Microelectrodes

“…In many microfluidic applications, e.g., fast chemical reactions, DNA separation and amplification, efficient microfluidic mixing schemes are required to ensure that a thorough species mixing can be achieved within small space and time scales. Micromixers are microfluidic systems which enable mixing two or several fluids into a homogenous solution, or control the dispersion of species in solvents (Karniadakis et al 2005;Nguyen and Wu 2005;Suh and Kang 2010;Lee et al 2011;Stevens et al 2012;Baheri Islami and Khezerloo 2017). Micromixers are often classified into two broad categories based on their operation mechanism: passive and active mixers.…”

The Physics and Manipulation of Dean Vortices in Single- and Two-Phase Flow in Curved Microchannels: A Review

“…Figure 3b shows a flow configuration including primary and secondary Dean vortices. The Dean number at which the secondary Dean vortices start to form is called the critical Dean number, De c [65,80,81].…”

Entropy generation analysis and thermal synergy efficiency in the T-shaped micro-kenics

“…To compare the performance of the micromixers, mixing index is formulated as below [ 48 , 49 ]: Where σ is the mass fraction's standard deviation, the definition is: With N denoting the number of sampling points throughouttransversal section, is the mass fraction atinspecting point i , the ideal mixing mass fraction is , and the standard deviation (SD) at the inlet section is .…”