Enhanced light management and optimization of perovskite solar cells incorporating wavelength dependent reflectance modeling

Comparative Study of Distinct Halide Composites for Highly Efficient Cesium-Based Perovskite Solar Cells

“…Figure (d) demonstrates that the PCE of CsPbI 2 Br exhibits a decline in value from 15.52% to 15.08% as the thickness of the CTL varied from 0.1 to 0.5 μm. The current study exhibits more favorable outcomes in comparison to the previous research conducted by Dipta et al…”

“…The PCE of CsPbBr 3 decreased steadily from 13.97% to 13.41% as the thickness of the CTL varied from 0.1 to 0.5 μm. The present study demonstrates superior results compared to the prior research conducted by Dipta et al 64 The modification of the thickness of the CTL in CsPbI 2 Br configurations is depicted in Figure 5, while the thickness of the CTL in the PSC was varied from 0.1 to 0.5 μm, and the optimal thickness required to achieve maximum efficiency in the simulated device was determined. Based on the data presented in Figure 5(a), it can be observed that the J SC of According to the data presented in Figure 6(a-d), it can be obtained that the four PV parameters, namely, J SC , V OC , FF, and PCE, exhibit a decrease in value as the temperature increases from 300 to 400 K for the perovskite material CsPbI 2 Br.…”

“…The PCE of the material CsPbI 2 Br rises from 13.02% to 15.52% at the maximum thickness level of the perovskite layer. The current work offers a better outcome than the previous work by Dipta et al…”

“…The PCE of CsPbBr 3 decreased steadily from 13.97% to 13.41% as the thickness of the CTL varied from 0.1 to 0.5 μm. The present study demonstrates superior results compared to the prior research conducted by Dipta et al…”

Comparative study of distinct halide composites for highly efficient perovskite solar cells using a SCAPS-1D simulator

“…So eventually a saturated J SC and reduced FF will reduce the PCE if PAL thickness is increased beyond a certain limit. The current work offers a better outcome than the previous work by Dipta et al 64 3.2 The inuence of the temperature on the PSC outputs Fig. 3a and b depicts a comprehensive examination of the PSC properties as temperature changes.…”