Enhanced heat transfer by thermosyphon method in electronic devices

Abstract

In the present work, the heat dissipation rate and thermal resistance of electronic cooling system is investigated with different coolants by two-phase closed loop thermosyphon method for both steady and unsteady state conditions. The coolants used in this study are acetone, alcohol and petrol respectively and are poured in the created test facility. A square heater of size 35 × 35 mm is fixed in the primary tank and used as a heat source. The heat input is given to the system varies from 10 to 60 W. The temperature of the experimental setup is measured by seven K-type thermocouples which are attached at various locations. Results indicate that (i) the convective heat transfer coefficient increases and thermal resistance decreases with increasing of heat input for all the coolants (ii) the acetone has high heat removal rate of 65.4 % at 60 W due to low boiling point, high latent heat of evaporation and less effect on subcooling, which directly helps in phase change process and heat extraction rate (iii) a maximum reduction in thermal resistance of about 0.523 0 C/W for acetone in comparison with alcohol and petrol by virtue of its high superheat which accelerates to nucleate boiling.

Synergistic effect of stearic acid/bismuth oxychloride/cupric oxide for thermal storage applications: preparation, stability, rheological and thermophysical analysis

“…The total uncertainty ( ¶ ) v is associated with the instrument uncertainty ( ¶ ) v I and repetition uncertainty ( ¶ ) v R when considering a parameter [24], which is calculated by: ¶…”

Model Development of a Thermosyphon Heat Pipe for the Temperature Management in a Wine Fermenter Tank

“…Finally, it is possible to write the final balance equation of the model, using Eqns. (2)(3)(4)(5)(6)(7)(8), excluding the contributes identified as negligible (i.e., Rcond,ax, Rpc,lv, Rpc,vl, Rv). The model, in its general form, can be written as follow:…”

“…These devices demonstrated to have a great potential in terms of heat transfer and achievable energy consumption reduction in many industrial fields such as electronical [6], including the food one [7][8][9].…”

Experimental Investigation of the Evaporator Section Tilted Angle and Filling Ratio on the Thermal Charateristics of a Two-phase Closed Thermosyphon

“…TS and other thermal devices for renewable energy applications such as in solar and geothermal can help you design more efficient, more cost-effective and greener systems [4]. Also, it can use for the electronic cooling system [5], heat transfer in permafrost regions [6].…”