Enhanced adsorption of chromium(VI) from aqueous medium by basic nanohydroxyapatite/chitosan composite based on egg shell

Hassan, Asaad F.; El-Naggar, Gehan A.; Braish, Amany G.; Amira, Mohamed F.; Alshandoudi, Laila M.

doi:10.5004/dwt.2020.26306

Cited by 5 publications

(2 citation statements)

References 63 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Nanohydroxyapatite was obtained from eggshell powder as reported previously, with slight modification [ 19 ]. The obtained eggshell powder was heated to 800 °C for 4 h (heating rate of 10 °C/min) to convert all the calcium carbonate into calcium oxide and to completely decompose all organic compounds [ 20 ].…”

Section: Methodsmentioning

confidence: 99%

Green Synthesis of Nano Zinc Oxide/Nanohydroxyapatite Composites Using Date Palm Pits Extract and Eggshells: Adsorption and Photocatalytic Degradation of Methylene Blue

et al. 2021

Self Cite

View full text Add to dashboard Cite

In this study, zinc oxide nanoparticles (ZnO) and nanohydroxyapatite (NHAP) were prepared in the presence of date palm pits extract (DPPE) and eggshells, respectively. Another four nanocomposites were prepared from ZnO and NHAP in different ratios (ZP13, ZP14, ZP15, and ZP16). DPPE and all nanomaterials were characterized using GC-MS, zeta potentials, particle size distributions, XRD, TEM, EDX, FTIR, and pHPZC. The characterization techniques confirmed the good distribution of ZnO nanoparticles on the surface of NHAP in the prepared composites. Particles were found to be in the size range of 42.3–66.1 nm. The DPPE analysis confirmed the presence of various natural chemical compounds which act as capping agents for nanoparticles. All the prepared samples were applied in the adsorption and photocatalytic degradation of methylene blue under different conditions. ZP14 exhibited the maximum adsorption capacity (596.1 mg/g) at pH 8, with 1.8 g/L as the adsorbent dosage, after 24 h of shaking time, and the static adsorption kinetic process followed a PSO kinetic model. The photocatalytic activity of ZP14 reached 91% after 100 min of illumination at a lower MB concentration (20 mg/L), at pH 8, using 1.5 g/L as the photocatalyst dosage, at 25 °C. The photocatalytic degradation of MB obeyed the Langmuir–Hinshelwood first-order kinetic model, and the photocatalyst reusability exhibited a slight loss in activity (~4%) after five cycles of application.

show abstract

Section: Methodsmentioning

confidence: 99%

Green Synthesis of Nano Zinc Oxide/Nanohydroxyapatite Composites Using Date Palm Pits Extract and Eggshells: Adsorption and Photocatalytic Degradation of Methylene Blue

et al. 2021

Self Cite

View full text Add to dashboard Cite

show abstract

“…The desorption efficiency of HCl: ethanol (2:1), HCl: ethanol (1:1), HCl: ethanol (1:2), HCl (0.1 M), ethanol (97%), butanol (99%), and distilled water were found to be 91, 54, 42, 38, 25, 20, and 7.3%, respectively. HCl: ethanol (2:1) is the most effective desorbing solution for pre-adsorbed methylene blue [63].…”

Section: Desorption Studiesmentioning

confidence: 99%

Adsorption and Photo-Fenton Degradation of Methylene Blue Using Nanomagnetite/Potassium Carrageenan Bio-Composite Beads

et al. 2022

Self Cite

View full text Add to dashboard Cite

The present study deals with the preparation of nanomagnetite (NM), potassium carrageenan (KC), and nanomagnetite/potassium carrageenan bio-composite beads (NC). Characterization of the prepared solid materials using different physicochemical techniques such as X-ray diffraction analysis (XRD), thermogravimetric analysis (TGA), scanning electron microscopy (SEM), transmission electron microscope (TEM), energy-disperse X-ray spectroscopy (EDX), diffuse reflectance spectrophotometer (DRS), swelling ratio (SR%), N2 adsorption, pH of point of zero charges (pHPZC), and Fourier transform infrared spectroscopy (FTIR). Comparing between adsorption and photo-Fenton degradation process for methylene blue (MB) on the surface of the prepared solid materials. Nanomagnetite/potassium carrageenan bio-composite (NC) exhibited high specific surface area (406 m2/g), mesoporosity (pore radius, 3.64 nm), point of zero charge around pH6.0, and the occurrence of abundant oxygen-containing functional groups. Comparison between adsorption and photo-Fenton oxidation process for methylene blue (MB) was carried out under different application conditions. NC exhibited the maximum adsorption capacity with 374.50 mg/g at 40 °C after 24 h of shaking time while 96.9% of MB was completely degraded after 20 min of photo-Fenton process. Langmuir's adsorption model for MB onto the investigated solid materials is the best-fitted adsorption model based on the higher correlation coefficient values (0.9771–0.9999). Kinetic and thermodynamic measurements prove that adsorption follows PSO, endothermic, and spontaneous process, while photo-Fenton degradation of MB achieves PFO, nonspontaneous, and endothermic process. Photo-Fenton degradation is a fast and simple technique at a lower concentration of dye (< 40 mg/L) while at higher dye concentration, the adsorption process is preferred in the removal of that dye.

show abstract

Optimization of batch process parameters for chromium (VI) removal from synthetic wastewater using eggshell–clay composite

Talukder,

Sultana,

Naim

et al. 2024

Discov Appl Sci

View full text Add to dashboard Cite

In this study, a biodegradable spherical adsorbent bead was developed from eggshell (ES) and Bijoypur clay (BC) for the removal of hexavalent chromium from synthetic tannery wastewater. This Eggshell–Clay polymer composite (ES–BC) was made by incorporating them with PVA and alginate. To analyze the morphology and chemical composition of the adsorbent before and after the chromium adsorption, SEM, FTIR, XRD, and EDX were used. The impact of adsorption parameters such as adsorbent dosage (0.67–2.23 g/L), pH of the solution (1.5–9), contact time (10–240 min), initial Cr (VI) concentration (25–100 ppm), and solution temperature (25–65 °C), percentage clay in ES-BC adsorbent (0–40%) for Cr (VI) adsorption were investigated. The optimum value for adsorbent dosage, pH, contact time, initial Cr concentration, temperature, and clay to eggshell ratio was found 1.17 g/L, 1.5, 150 min, 58.2 ppm, 25 °C, and 80/20% respectively. The isotherm model was well-fitted to the Freundlich isotherm suggesting heterogeneous adsorption in multilayer on surface. The adsorption kinetics followed pseudo-second-order kinetics supporting the chemisorption process. Moreover, a decrease in enthalpy (H°) and negative Gibbs free energy (G°) with increased temperature indicated exothermic and spontaneous reaction. Therefore, this research investigated that the composite may serve as a viable option for treating Cr (VI) containing tannery effluent.

show abstract

Enhanced adsorption of chromium(VI) from aqueous medium by basic nanohydroxyapatite/chitosan composite based on egg shell

Cited by 5 publications

References 63 publications

Green Synthesis of Nano Zinc Oxide/Nanohydroxyapatite Composites Using Date Palm Pits Extract and Eggshells: Adsorption and Photocatalytic Degradation of Methylene Blue

Green Synthesis of Nano Zinc Oxide/Nanohydroxyapatite Composites Using Date Palm Pits Extract and Eggshells: Adsorption and Photocatalytic Degradation of Methylene Blue

Adsorption and Photo-Fenton Degradation of Methylene Blue Using Nanomagnetite/Potassium Carrageenan Bio-Composite Beads

Optimization of batch process parameters for chromium (VI) removal from synthetic wastewater using eggshell–clay composite

Contact Info

Product

Resources

About