Engineering method for thermal calculation of the vortex combustion in dead-end fire-tubes

Abstract

Abstract. In article the method for predicting the vortex formation in the dead-end furnace is described. Mass and heat balances of environment in the vortex are calculated using the computer simulation with ANSYS Fluent software. Engineering approach for quantitative analysis of singularities in the reversible flame is proposed. Assessment of vortices integral characteristics, including effects on the aerodynamics and heat transfer processes in dead-end furnace, is given.

Researching the Performance of Dual-Chamber Fire-Tube Boiler Furnace

“…For the described layout there are approximate equations of quasi-one dimensional method of recirculating fraction calculation applied to the combustion chamber with reversed flame [10]. In order to estimate the impact of the recirculating flue gases on the integral boiler performance characteristics in paper [10] is suggested to use the relative value of the recirculation flow (r). It can be defined as volumetric flow rate of the recirculating flue gases divided by total volume flow through the furnace:…”

“…2). Interrelation between frontal and impasse connection channels gaseous medium characteristics can be estimated with this equation [10]:…”

Small Distributed Energy Russia: Combined Heat and Power Generation

“…Currently, the power generation in decentralized areas is mainly produced by diesel stations that not economically efficient. Wherein such areas often have reserves of local low grade fuels, but their consumption is accompanied by appropriate technical devices [11][12][13].…”

The Study of Gas-Dynamic Processes in the Current Boiler Fluidized Bed

“…The study was carried out using the program ANSYS Fluent 12.1.4 with the methods described in [5,10,11]. For simplicity and speed of calculation two-dimensional computational grid of combustion chamber lower part was used (Fig.…”