Energy storage systems and their sizing techniques in power system — A review

Ali, Abid; Nor, Nursyarizal Mohd; Ibrahim, Taib

doi:10.1109/cencon.2015.7409542

Cited by 37 publications

(25 citation statements)

References 46 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…), chemical (fuel cells, electrolysers), electric accumulating energy in the electrical field -supercapacitors, or in the magnetic field -].Popular examples of their application are presented [2].…”

Section: Energy Storages Used In Electrical Vehiclesmentioning

confidence: 99%

“…the energy density and power density which a given storage may accumulate. These parameters are the main factors, which determine the application of various energy storages [1][2]. The sources of electric energy also become more and more popular because of a great increase in the number of portable electrical and electronic equipment such as laptops, mobile phones, etc.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Modelling and simulation of lead-acid battery pack powering electric vehicle

Burzyński

Kasprzyk

2017

E3S Web Conf.

View full text Add to dashboard Cite

Abstract. This paper presents aspects of modelling and simulation of energy storages based on the example of a lead-acid battery pack for powering an electric vehicle. The most frequently used energy storages, with particular emphasis on the difficulties in their proper selection for mobile equipment, was discussed. The mathematical model of the leadacid battery and the relations describing its respective parameters was also presented. A selected energy storage was subjected to detailed analysis with regards to the electrical and thermal parameters while powering an electric vehicle during an standard driving cycle in an urban area. The simulation was performed in the Matlab Simulink environment.

show abstract

Section: Energy Storages Used In Electrical Vehiclesmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Modelling and simulation of lead-acid battery pack powering electric vehicle

Burzyński

Kasprzyk

2017

E3S Web Conf.

View full text Add to dashboard Cite

show abstract

“…A SMES is a device which stores electric energy by dc current flowing through a superconducting coil which creates a strong magnetic field. SMES is more advantageous in comparison to other energy storage systems as demonstrated in Table …”

Section: System Modelingmentioning

confidence: 99%

“…SMES is more advantageous in comparison to other energy storage systems as demonstrated in Table 1. 21,[25][26][27][28][29] This system consists of (1) power transformer, (2) voltage source converter (VSC), (3) DC link capacitor, (4) DC-DC chopper, (5) superconducting coil, and (6) bypass switch. Bypass switch reduces energy losses when the coil is on standby and protects the coil when the converter fail to service, cooling system, and main power supply is lost.…”

Section: Smes Modelmentioning

confidence: 99%

A new controlled superconducting magnetic energy storage for dynamic stabilization of distributed generation in islanding mode of operation

Asadi

Meyar‐Naimi

Jahangiri

2017

Int Trans Electr Energ Syst

View full text Add to dashboard Cite

Summary According to IEEE std. 1547, islanding mode is “a condition in which a portion of an Electric Power System (EPS) is energized solely by one or more local EPSs through the associated Point of Common Coupling (PCC) while that portion is electrically separated from the rest of the area EPS”. Therefore, the dynamic instability due to islanding may result in power swing and finally loss of synchronism. Hence, many studies have been done for islanding detection and disconnection of distributed generation (DG) in an EPS. But, these conventional methods eventually lead to the disconnection of the DG units. To improve DG dynamic stability, superconducting magnetic energy storage (SMES) can be used effectively, because SMES have a high‐energy density and fast response. This paper proposes a new method to damp the power swing after DG islanding and to maintain synchronism conditions based on SMES. Hence, the disconnection of the DG units is not required. Also, new controllers are developed for SMES including voltage source converter (VSC), and DC‐DC chopper. The controller structures of VSC and DC‐DC chopper are of PI and fuzzy logic‐based type, respectively. Superconducting coil charging is controlled by the DC‐DC chopper. SMES sizing is performed, based on power swing equations. Hereupon, dynamic load model is considered. Performance of the proposed method is evaluated by defining 12 scenarios such as strong and weak networks with load changing simulated in PSCAD. Simulation results show that the islanded DG stabilization (IDGS) method has good performance to maintain stability margin in a weak network.

show abstract

“…Therefore, BESS has been widely applied in distributed grids [32]. BESS consists of different storage technologies referred to as 'batteries'.…”

Section: Bess Technologymentioning

confidence: 99%

Energy hub modeling to minimize residential energy costs considering solar energy and BESS

Zhang

Thang

et al. 2017

J. Mod. Power Syst. Clean Energy

View full text Add to dashboard Cite

This paper aims to optimize total energy costs in an operational model of a novel energy hub (EH) in a residential area. The optimization problem is set up based on daily load demand (such as electricity, heat, and cooling) and time-of-use (TOU) energy prices. The extended EH model considers the involvement of solar photovoltaic (PV) generation, solar heat exchanger (SHE), and a battery energy storage system (BESS). A mathematical model is constructed with the objective of optimizing total energy cost during the day, including some constraints such as input-output energy balance of the EH, electricity price, capacity limitation of the system, and charge/discharge power of BESS. Four operational cases based on different EH structures are compared to assess the effect of solar energy applications and BESS on the operational efficiency. The results show that the proposed model predicts significant changes to the characteristics of electricity and gas power bought from utilities, leading to reduced total energy cost compared to other cases. They also indicate that the model is appropriate for the characteristics of residential loads.

show abstract

Energy storage systems and their sizing techniques in power system — A review

Cited by 37 publications

References 46 publications

Modelling and simulation of lead-acid battery pack powering electric vehicle

Modelling and simulation of lead-acid battery pack powering electric vehicle

A new controlled superconducting magnetic energy storage for dynamic stabilization of distributed generation in islanding mode of operation

Energy hub modeling to minimize residential energy costs considering solar energy and BESS

Contact Info

Product

Resources

About