Energy Efficiency in the Cement Industry

Energy, Directorate-General for; Brussels,; Belgium,

doi:10.4324/9780203215654

Cited by 5 publications

(2 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In recent years all over the world in the construction of residential buildings emphasis on low energy consumption and the construction of energy-efficient buildings. In the last decade in Europe, energy efficiency of buildings has been one of the main directions of development of the construction industry [1][2][3][4][5][6][7][8][9]. Standard documentation of the European countries contributes to this objective, in most developed countries of the world the norms of energy consumption by buildings constantly decreasing, and requirements to the level of thermal insulation enclosing structure increase [9][10][11][12][13][14][15][16][17].…”

Section: The Overviewmentioning

confidence: 99%

Reduced Thermal Resistance of a Two-Layer Wall Construction

Горшков

Ivanova

2015

AMM

View full text Add to dashboard Cite

show abstract

Section: The Overviewmentioning

confidence: 99%

Reduced Thermal Resistance of a Two-Layer Wall Construction

Горшков

Ivanova

2015

AMM

View full text Add to dashboard Cite

show abstract

“…She considers that the complex solution which it proposes, allows to reduce power consumption by engineering systems of the building. It realizes in uniform system of function of heating, cooling, hot water supply, unites one contour sources of warmth and cold in the building [30].…”

Section: The Overviewmentioning

confidence: 99%

The Energy-Efficient Heat Insulation Thickness for Systems of Hinged Ventilated Facades

Vatin

Горшков

Nemova

et al. 2014

AMR

View full text Add to dashboard Cite

Calculation of payback periods of the energy saving actions directed on increase of level of thermal protection of external enclosure structures of buildings is given. Economic efficiency of investments in energy saving actions is analyzed and the model allowing to carry out the specified analysis is offered. Recommendations about reduction of payback periods are provided.Article also is devoted definition of optimum, economically well-founded thickness of a insulant in systems of rear ventilated facades. Are resulted thermotechnical and economic calculations. The optimum thickness of the insulant in the given systems is offered.A number of the energy saving actions is necessary for economy of thermal energy, allowing to eliminate defects of protecting designs or to reduce their influence on building heatconsumption. Construction of hinged ventilated facades at simultaneous introduction of automated individual thermal points with automatic equipment dependent on weather [1] can become an example of the engineering decision on increase of heat-shielding properties of protecting walls.

show abstract