Energy efficiency and transient-steady state performance comparison of a resistance infant incubator and an improved thermoelectric infant incubator

Yeler, Osman; Koseoglu, M.F.

doi:10.1016/j.jestch.2021.09.001

Cited by 3 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Premature babies tend to have lower activity levels, less responsiveness, higher sensitivity, and more reluctance to gaze when compared to babies born at the right time [9]. A major challenge for babies born prematurely is their inability to regulate their body temperature [10]. Babies are protected from bacteria and germs from the outside environment by providing heating at a temperature that matches the temperature when the baby is in the mother's womb.…”

Section: Introductionmentioning

confidence: 99%

PID Temperature Control of Baby Incubator Transport Battery Efficiency

Vidaryanto,

Wisana,

Kholiq

et al. 2024

j.teknokes

View full text Add to dashboard Cite

Transport baby incubators are used to keep babies warm and safe while in transport using battery voltage sources or DC electricity, which are portable and can be used without getting a supply of electrical energy. The problem that often occurs with this tool is the limited battery power system. causes a risk to the infant in the event of power failure or battery exhaustion. We aim to evaluate the battery efficiency of Baby Incubator Transport using a PID temperature controller. The evaluation is done by comparing and analyzing the battery voltage of the device to the standard device, as well as considering the setting temperature and duration of use of the device so that it can provide convenience in evacuating babies in an emergency. The tool uses the PID method to control temperature and maximize battery power. In this design, researchers only look at the efficiency of the PID method on temperature control and the battery to be used. This module will have a display that will display the battery voltage value, battery voltage percentage, skin temperature, chamber temperature, humidity, and temperature control that has been selected in the form of a graph. Compared with the digital multimeter measuring instrument. From the results of data collection, it can be concluded that the PID method has a faster rise time to reach the setting temperature, while the fuzzy method has a longer rise time to reach the setting temperature. However, the PID method requires more battery power than the Fuzzy method. The measurement results between the display and the measuring device have a difference of 3.1% at 34°C, at 35°C it is 3.9%, and at 36°C it is 4.7%. The biggest error is at a temperature of 36ºC, the smallest is at a temperature of 34ºC. Based on the results of the observation analysis of battery power consumption, it is found that the smaller the battery energy, the smaller the current issued, as well as the voltage issued. But if the load is large, the current is inversely proportional to the center, the battery voltage decreases while the current increases.

show abstract

Section: Introductionmentioning

confidence: 99%