Electron‐beam curing of bismaleimide‐reactive diluent resins

Abstract

Electron-beam (E-beam) curing of 4,4Ј-bismaleimidodiphenylmethane (BMPM)/BMI-1,3-tolyl/o,oЈ-diallylbisphenol A (DABPA)-based bismaleimide (BMI) systems and their mixing with various reactive diluents, such as N-vinylpyrrolidone (NVP) and styrene, were investigated to elucidate how temperature, electron-beam dosage, and diluent concentration affect the cure extent. The effect of freeradical initiator on the cure reactions was also studied. It was found that low-intensity E-beam exposures cannot cause the polymerization of BMI. High-intensity E-beam exposures give high reaction conversion attributed to a high temperature increase, which induced thermal curing. It was shown that the dilution and activation of NVP in BMI cause a more complete BMI cure reaction under E-beam radiation.BMI/NVP can be initiated easily by low-intensity E-beam without thermal curing. FTIR studies indicate that about 70% of the reaction is complete for BMI/NVP with 200 kGy dosage exposure at 10 kGy per pass. The sample temperature only reaches about 75°C. The free-radical initiator, dicumyl peroxide, can accelerate the reaction rate at the beginning of E-beam exposure, but does not affect the final reaction conversion. The increase of the concentration of NVP in the BMI/NVP systems increases the reactive conversions almost linearly.

Maleimide-Based Alder-Enes

“…Electron-beam curing was attempted for the BMPM/DABA system with various reactive diluents, such as N-vinylpyrrolidone (NVP) and styrene [73]. It was observed that BMPM/NVP can be initiated easily by low-intensity E-beam without thermal curing.…”

Electron beam curing of functionalized N-(4-hydroxy phenyl)maleimide monomers

“…Reactive vinyl diluents such as NVP, styrene, acrylonitrile, acrylates and methylacrylates are widely used to assist in BMI curing reactions. 17,18 Li et al 19 studied E-beam curing of BMI having reactive diluents. The reactive diluents chosen for the investigation were styrene and NVP.…”

Gamma Ray Irradiation‐Initiated Copolymerization of a Binary Casting System Involving DPBMIn and Vinylpyrrolidone

“…[13] Recently some researches were conducted on polyimide related to gamma ray irradiation. [12,14] In this paper, a series of homogeneous binary casting systems composed of bismaleimide oligomer DPBMI n and vinylpyrrolidone (NVP) as reactive solvent were developed.…”

“…Recently, E‐beam was used to cure bismaleimide‐reactive diluent resin for many advantages of irradiation cure over conventional thermal cure 13. Recently some researches were conducted on polyimide related to gamma ray irradiation 12,14.…”