Electrochemical Study on a Hybrid Device of a Lithium-Ion Capacitor and a Lithium-Ion Battery using 8-Reference Electrodes

Mitsuda, Kenro; Kise, Makiko; Aihara, Shigeru; Okada, Tatsunori

doi:10.5796/electrochemistry.79.547

Cited by 1 publication

(1 citation statement)

References 12 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…，固体高分子形燃料電池(燃料欠乏と空気欠乏) 19 ，電気二重層キャパシタ(端部異常腐食) 20,21 ，リチウムイオンキャパシタ(Li ドープ) 22 ，バッテリ複合型キャパシタ(電流分担) 23 ，鉛蓄電池(成層化現象) 24 などの電気化学デバイスのセル面内の電位挙動を解析し報告している． 861-871 (2016) Positive-side) と正極に対峙しない負極張り出し辺 (Jutting Negative-side) を設けたセル，Type B ( Fig. 1(B Electrochemistry, 84(11), 861-871 (2016) Fig.…”

unclassified

Polarization Study and AC-Impedance Measurement in the Horizontal Plane of a Lithium-ion Battery Using Eight Reference Electrodes

2016

Self Cite

View full text Add to dashboard Cite

Eight reference electrodes (Li/Li + ) were embedded around a square (30 mm × 30 mm) lithium-ion battery (LIB) cell (Type A or Type B), and the electrical potential changes of the positive and negative electrodes against the reference electrodes (Rx; x-1-8) during charge and discharge were studied. Type A has a jutting positive-side (JPside) and a jutting negative-side (JN-side). During the charge and discharge of Type A, significant potential shifts (>1.3 V) in the horizontal plane of the cell were observed near the JP-side and JN-side, but which were relieved after several hours. The potential shifts in the horizontal plane of the cell (the difference between the maximum and the minimum of P-Rx (x = 1-8) or N-Rx (x = 1-8)) were caused by the relaxation current between P and JP-side or between N and JN-side. AC impedance measurements also were conducted with the cells several hours after they reached a specific SOC level. Linear relations were obtained at wide frequencies between the ratio of P-Rx (x = 1-8) and Z′ (Real) or Z′′ (Imaginary) resistance. The sharing rate of P-Rx (x = 1-8) in Z′ (Real) or Z′′ (Imaginary) resistance was mainly determined by the position of the reference electrode which was close to the edge of the positive electrode or that of the negative one. It was found that when a reference electrode is installed outside of the cell, it is difficult to divide the impedance into both electrodes by the AC impedance measurements with the reference electrode.

show abstract