Electrocatalysis and electroanalysis of nickel, its oxides, hydroxides and oxyhydroxides toward small molecules

Miao, Yuqing; Ouyang, Lei; Zhou, Shilin; Xu, Le; Yang, Zihan; Xiao, Mingshu; Ouyang, Ruizhuo

doi:10.1016/j.bios.2013.10.008

Cited by 251 publications

(172 citation statements)

References 84 publications

Supporting

Mentioning

158

Contrasting

Unclassified

Order By: Relevance

“…The computed values were obtained from a consideration of the electronic and ionic (produced by the IR vibrational modes) contributions to ε 0 , and at 0 K yielded ε 0 ⊥ = 6.83 and ε 0 // = 4. 23. Their average is ε 0 = 5.96, which is an overestimate of the experimental value of 4.1 at 150 K. The discrepancy between experiment and theory is attributed to differences in the measured and calculated IR oscillator strengths [215].…”

Section: (C) Electronic Properties (I) Dielectric Propertiesmentioning

confidence: 76%

Nickel hydroxides and related materials: a review of their structures, synthesis and properties

et al. 2015

View full text Add to dashboard Cite

This review article summarizes the last few decades of research on nickel hydroxide, an important material in physics and chemistry, that has many applications in engineering including, significantly, batteries. First, the structures of the two known polymorphs, denoted as α-Ni(OH) 2 and β-Ni(OH) 2 , are described. The various types of disorder, which are frequently present in nickel hydroxide materials, are discussed including hydration, stacking fault disorder, mechanical stresses and the incorporation of ionic impurities. Several related materials are discussed, including intercalated α-derivatives and basic nickel salts. Next, a number of methods to prepare, or synthesize, nickel hydroxides are summarized, including chemical precipitation, electrochemical precipitation, sol-gel synthesis, chemical ageing, hydrothermal and solvothermal synthesis, electrochemical oxidation, microwaveassisted synthesis, and sonochemical methods. Finally, the known physical properties of the nickel hydroxides are reviewed, including their magnetic, vibrational, optical, electrical and mechanical properties. The last section in this paper is intended to serve as a summary of both the potentially useful properties of these materials and the methods for the identification and characterization of 'unknown' nickel hydroxide-based samples.

show abstract

Section: (C) Electronic Properties (I) Dielectric Propertiesmentioning

confidence: 76%

Nickel hydroxides and related materials: a review of their structures, synthesis and properties

et al. 2015

View full text Add to dashboard Cite

show abstract

“…They have received continuously increasing interest in the recent years [13,14]. The nickel-based materials have been utilized for the electrocatalysis of glucose in alkaline media where the electrocatalytic mechanism of Ni to glucose involves the shift of Ni(OH) 2 /NiOOH couple [15]. An previous investigation found that potential scanning nano-NiO modified carbon paste electrodes up to high potential in alkaline solution greatly increases the amount of redox couple Ni(OH) 2 /NiOOH derived from NiO, and thus improves their electrochemical properties and electrocatalytical performance toward the oxidation of glucose [16].…”

Section: Introductionmentioning

confidence: 99%

Promotion Effect of Bismuth on Nickel Electrodeposition and Its Electrocatalysis to Glucose Oxidation

Miao

Liang

et al. 2014

Electroanalysis

Self Cite

View full text Add to dashboard Cite

Metallic Bi and Ni were co‐deposited onto the surface of glass carbon electrode (GCE) from the electrolyte solution containing their respective nitrate to fabricate a Bi/Ni alloy modified GCE (Bi/Ni‐GCE). The purpose is to study the influence of Bi3+ on the deposition of Ni and that of deposited Bi on the electrocatalytic performance of Ni to glucose in alkali solution. The results show that both redox signal of Ni(OH)2/NiOOH and Ni(OH)2/NiOOH mediated electrocatalysis to glucose is remarkably increased in the presence of Bi. It seems that there is a synergistic effect between Bi and Ni on each other’s redox electrochemistry. It’s possible that the firstly deposited Bi on GCE surface helps to the following nucleation and growth of Ni, leading to the deposition of more metallic Ni on GCE surface. An extremely attractive feature of Bi/Ni‐GCE is reflected by the fast response time to the electrocatalytic oxidation of glucose. The electrode nearly responses immediately after glucose is added and it reaches a steady‐state level within only 2 seconds, demonstrating a good electrocatalytic property of Bi/Ni‐GCE. The calibration plot is linear over the wide concentration range of 0–5.8 mM with a sensitivity of 33.96 µA/mM and a correlation coefficient of 0.9985. The detection limit of the glucose was found to be 0.59 µM at a signal‐to‐noise ratio of 3. The fabricated Bi/Ni‐GCE was successfully employed to analyze the glucose level in blood samples, exhibiting high accuracy, strong resistance against inference and good reliability in the practical applications.

show abstract

“…From a variety of descriptions regarding anodic film formation on Ni surface over all the pH range [20,21], we suggest that in anhydrous neutral solutions, methanol is autodissociated [22] according to the scheme:…”

Section: Resultsmentioning

confidence: 99%

Differential capacitance and electrochemical impedance study of surfactant adsorption on polycrystalline Ni electrode

Anastopoulos

Papoutsis

Papaderakis

2015

J Solid State Electrochem

View full text Add to dashboard Cite

The adsorption of neutral organophosphorous compounds on a charged polycrystalline Ni electrode is studied by differential capacitance and impedance measurements in methanol solutions. Analysis of capacitance measurements reveals that tributylphosphine oxide, tri(n)octylphosphine oxide, and triphenylphosphine follow Langmuir adsorption isotherm. Saturation capacitance C sat , potential of maximum adsorption E max , limiting surface concentration Γ max , and standard Gibbs energy of adsorption ΔG max o at E max are determined. The cathodic reduction of (NiOCH 3 ) ads film formed on Ni surface at positive potentials, introducing a faradaic contribution in addition to the electrostatic charging of the interface, is supported by linear sweep voltammetric and impedance measurements. High values of electrode coverage and strong depression of faradaic currents are attained, indicating that these adsorbates may be suitable as corrosion inhibitors.

show abstract

Electrocatalysis and electroanalysis of nickel, its oxides, hydroxides and oxyhydroxides toward small molecules

Cited by 251 publications

References 84 publications

Nickel hydroxides and related materials: a review of their structures, synthesis and properties

Nickel hydroxides and related materials: a review of their structures, synthesis and properties

Promotion Effect of Bismuth on Nickel Electrodeposition and Its Electrocatalysis to Glucose Oxidation

Differential capacitance and electrochemical impedance study of surfactant adsorption on polycrystalline Ni electrode

Contact Info

Product

Resources

About