Efficiency Dependence of Radiation-Assisted Ceramic Synthesis Based on Metal Oxides and Fluorides on Initial Powder Particle Sizes
Victor Lisitsyn,
Elena Polisadova,
Liudmila Lisitsyna
et al.
Abstract:The study is devoted to investigating the efficiency dependence of radiation-assisted ceramic synthesis based on metal oxides and fluorides on initial powder particle sizes. The synthesis was performed for 30 series of ceramic samples, including MgO, Al2O3, ZnO, ZrO2, MgF2, and complex compositions: cerium-activated yttrium-aluminum garnet (Y3Al5O12), spinel AlMgO4, and tungstate MgWO4. The synthesis efficiency was evaluated on the mixture weight magnitude losses, morphology, and relative weight of the obtaine… Show more
Laser spectroscopy offers a significant tool for revealing specific molecular details with the desired accuracy and sensitivity. However, it poses challenges to maintain high sensitivity when targeting a micro‐region. Here, a dual‐enhanced photothermal approach is presented using a high‐finesse fiber Fabry–Pérot (F–P) cavity, tailored for highly sensitive chemical sensing with nanoliter‐scale light–matter interaction. A spheric surface (diameter: 50 µm, radius of curvature: 910 µm) is created on the fiber tip using focused ion beam milling. By adding a high‐reflectivity dielectric coating to the spheric surface, a fiber F–P cavity is obtained with a length of 473 µm and a finesse exceeding 4000. The intra‐cavity pump light within the gas‐filled fiber cavity generates a strong photothermal effect upon gas absorption. This effect induces phase modulation, which is amplified and detected by coupling a probe laser to the fiber cavity‐based interferometer. A minimum detection limit of 10 parts‐per‐billion (ppb) of C2H2 at 1530.37 nm is demonstrated using only 1 mW of pump power, corresponding to a normalized noise equivalent absorption coefficient of 9.1×10−11 cm−1∙W∙Hz−1/2. This platform breaks the bottleneck of ultrasensitive gas detection with a very short light–matter interaction length, promising significant advancements in microscale chemical analysis through optical investigations.
Laser spectroscopy offers a significant tool for revealing specific molecular details with the desired accuracy and sensitivity. However, it poses challenges to maintain high sensitivity when targeting a micro‐region. Here, a dual‐enhanced photothermal approach is presented using a high‐finesse fiber Fabry–Pérot (F–P) cavity, tailored for highly sensitive chemical sensing with nanoliter‐scale light–matter interaction. A spheric surface (diameter: 50 µm, radius of curvature: 910 µm) is created on the fiber tip using focused ion beam milling. By adding a high‐reflectivity dielectric coating to the spheric surface, a fiber F–P cavity is obtained with a length of 473 µm and a finesse exceeding 4000. The intra‐cavity pump light within the gas‐filled fiber cavity generates a strong photothermal effect upon gas absorption. This effect induces phase modulation, which is amplified and detected by coupling a probe laser to the fiber cavity‐based interferometer. A minimum detection limit of 10 parts‐per‐billion (ppb) of C2H2 at 1530.37 nm is demonstrated using only 1 mW of pump power, corresponding to a normalized noise equivalent absorption coefficient of 9.1×10−11 cm−1∙W∙Hz−1/2. This platform breaks the bottleneck of ultrasensitive gas detection with a very short light–matter interaction length, promising significant advancements in microscale chemical analysis through optical investigations.
This paper presents the results of a study on the morphology, structure, and luminescent properties of ceramics synthesized in the radiation field of MeWO4 compositions (where Me is Mg, Ca, and Zn). The synthesis of ceramics was carried out by the direct action of the electron flux on an initial mixture of powders of the given stoichiometric composition. WO3, ZnO, MgO, and CaO powders with particle sizes in the range of 1–50 microns were used for the synthesis of the samples. It was found that the yield of the radiation synthesis reaction (the ratio of the mass of the sample and the charge used), when treated with an electron flux with an energy of 1.4 MeV and a flux power density of 15–18 kW/cm2, was in the range of 75–99%. The synthesis of all compositions was carried out under the same radiation treatment modes, although the melting temperatures of the starting materials varied significantly and ranged from 1473 °C (WO3) to 2825 °C (MgO). The study of the ceramic structure showed that under the radiation effect of powerful radiation fluxes on the charge, a crystalline phase of the appropriate composition formed, regardless of the synthesis modes. The results of XRD studies show that during the radiation treatment of the charge, ceramics are formed mainly with the crystalline phases ZnWO4, MgWO4, and CaWO4. These resulting MeWO4 ceramics can be used for the same purposes as crystals. Photoluminescence (PL) and cathodoluminescence (CL) were studied under excitation using stationary ultraviolet radiation and nanosecond pulses of electron flux. In general, the PL and CL of synthesized ceramic samples ZnWO4, MgWO4, and CaWO4 showed that their luminescent properties are similar to those of luminescence in corresponding crystalline materials. This indicates the formation of a crystalline phase in synthesized ceramic samples.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.