Effects on Micro-Surface Texturing of Mg/B4C Matrix Composites Under Dry Sliding Wear Condition

Murugesan, K.; Suresh, S.; Vettivel, S.C.

doi:10.1007/s12666-020-01913-z

Cited by 5 publications

(1 citation statement)

References 36 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…it is a result of the high hardness property of B 4 C & MoS 2 and the uniform distribution of reinforcement particles within the al matrix. Many other researchers have observed similar trends [15,27,28]. the density of the composite is found to decrease with an increase in reinforcement due to the minimum density of reinforcements (B 4 C and MoS 2 ).…”

Section: Effect Of Hardness Density and Porositysupporting

confidence: 60%

Archives of Metallurgy and Materials

2022

View full text Add to dashboard Cite

Influence of AcoustIc emIssIon sIgnAls And dAmAge AnAlysIs durIng the tensIle test on Al8011 hybrId composItes by stIr cAstIng methodMetal network compounds have primary properties. the use of lightweight and low vitality is a testament to the growing interest in the automotive industry. aluminum alloys, due to their advanced physical, mechanical and tribological properties, have become a highly emerging material for a variety of industrial applications and the importance of efficient material selection is explained. in this paper, an al8011 hybrid metal matrix composite is developed through the stir casting process. the different weight proportions of B 4 C (3%, 6%, 9% & 12%) and fixed proportions of 2% MoS 2 have been used. Composite developed are subjected to mechanical properties evaluation and seawater corrosion studies following standard procedures. to study the porosity of the composite samples, theoretical density and actual density are calculated. an acoustic emission system-assisted tensile test is carried out to report the strength of the composite. From this experimental method, adding reinforcement can increase the tensile strength and hardness of the composites. under sea water, the increase in reinforcement found an increase in corrosion resistance. Fractured surfaces were perused using SeM and eDS analysis.

show abstract

Section: Effect Of Hardness Density and Porositysupporting

confidence: 60%