Effects of tensile strength on friction welding condition and weld faying surface properties of friction welded joints between pure copper and austenitic stainless steel

Kimura, Masao; Ohara, Kohei; Kusaka, Masahiro; Kaizu, Koichi; Hayashida, Kazuhiro

doi:10.1016/j.jajp.2020.100028

Cited by 21 publications

(1 citation statement)

References 33 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The width of the thermo mechanically-affected zone (TMAZ) was reduced with friction pressure or/and shear velocity, while the width of the weld centre zone (WCZ) remained constant. Kimura et al [16] The authors investigated the effects of tensile strength on friction welding condition and weld faying surface properties of friction welded joints between pure copper and austenitic stainless steel (AISI 304). The joining phenomena and the joint tensile strength at various friction welding conditions were investigated.…”

Section: Literature Reviewmentioning

confidence: 99%

Latest Developments in Friction Welding- A Review

Manzoor¹,

Singh²,

Saini³

2023

IJRASET

View full text Add to dashboard Cite

Friction welding has been used for joining the two metal or alloys by the force of friction and it is having numerous benefits over the other conventional methods of joining the alloys. Some of the benefits obtained by this welding are better tensile strength, refine grain hardness, microstructure improvement and metallurgical properties over the parent metal. So, the prime intention of this study is to review the latest trends in the field of friction welding and throwing the light on some aspects which have not realised the potential yet. Therefore, in this research article some stories of the friction welding are collected and analysed on the basis of the parameters, testing and type of materials used for the welding purposes. From most of the articles quoted, it has been found that rotational speed was found to be the dominating parameter among them but the parameter of heat input and stress analysis through latest methods have not used upto that level. On the basis of this review, some recommendations for the manufacturing sectors are highlighted here which may prove to be useful for the industrial applications in the forthcoming times

show abstract

Section: Literature Reviewmentioning

confidence: 99%