Effects of printing direction on quasi‐static and dynamic compressive behavior of 3D printed short fiber reinforced polyamide‐based composites

Abstract

This paper investigated the effects of printing directions (path of nozzle movement) and strain rates on the performances of short carbon and glass fibers filled polyamide-based composites prepared by fused deposition modeling (FDM). Cylindrical specimens printed in three different printing directions were compressed at a wide range of strain rate. The results showed that, for short fiber reinforced polyamide, the compressive properties of cylindrical specimens were affected by printing directions closely associated with the fiber orientation. The highest elastic modulus and yield strength of short fiber reinforced specimens were obtained when the printing direction was parallel to the applied loading direction, because the orientation of short fibers was preferred to the printing direction. However, at large deformation, the orientation of fibers in specimens changed, accompanied by a decrease in stress. With increasing strain rates, the short fiber reinforced polyamide with different fiber orientations showed different failure modes. However, the compressive behaviors of pure polyamide were similar, although they were printed in different printing directions.

Effect of continuous fiber orientations on quasi‐static indentation properties in 3D printed hybrid continuous carbon/Kevlar fiber reinforced composites

“…To meet the demand for advanced composites with complicated geometry in various fields, three‐dimensional (3D) printing, also referred to as additive manufacturing (AM), was invented to build complex parts efficiently due to the advantages of high precision and high manufacturing speed 4–6 . The fused deposition method (FDM) which constructed structures by printing layer by layer based on digital information, 7 was one of the most commonly used AM methods because of its flexibility, low cost, high material usage, and environmental friendliness 8–10 …”

Investigation on dynamic strength of 3D‐printed continuous ramie fiber reinforced biocomposites at various strain rates using machine learning methods

“…[1,[18][19][20][21][22][23] In addition, the dynamic mechanical properties of 3D-printed composites could differ significantly compared with the quasi-static mechanical properties due to the strain rate effect. [21,24] Thus, it is essential to investigate the dynamic mechanical properties of 3D-printed continuous natural fiber reinforced composites to boost their industrial application.…”