Effects of occlusal force loading on tooth movement in six degrees of freedom. Development of an analysis system.

Abstract

Abstract:The purpose of this research was to evaluate tooth movement in six degrees of freedom under occlusal force loading. The right side upper first premolar movement of an adult volunteer without any signs or symptoms of periodontal disease was studied. A small occlusal table mounted on a force transducer was clipped between the upper and lower dentition. Occlusal force was applied to the buccal cusp, palatal cusp or central fossa of the first premolar and also to the right side canine aspect by clenching this occlusal table.The right side first premolar movement relative to the left side first premolar was measured by means of a highresolution six degrees of freedom motion detector. The three-dimensional shape of the first premolar was measured with following methods. A 3-D digitizer with a touch sensor probe was used to measure the coronal part of a cast stone model of the tooth. Computerized tomography data were used to obtain the root shape of the tooth. These movement and configuration data were combined to perform computer graphics analysis of the three-dimensional tooth movements. The range and direction of tooth movement were varied by altering the position and amplitude of occlusal force loading. Since the magnitude of the tooth movements was relatively small, we adapted the screw axis (helical axis) concept to emphasize tooth movement on the computer graphics representations.

Bite forces and their resultants during forceful intercuspal clenching in humans

“…Indeed, posterosuperior condylar displacement reaches an average of 0.81 mm during maximal intercuspal clenching (Santosa et al;2006), whereas the amount of tooth movement under occlusal loads is less than 0.15 mm on average (Satsuma et al, 2002). The discrepancy between condylar and dental displacements can also cause the proximity of the posterior part of the mandibular corpus to the maxilla, and can contribute to the slanted bite-force distribution.…”

Current status of researches on jaw movement and occlusion for clinical application

“…Such tooth movement is found not only in loaded teeth, but also in adjacent teeth without direct occlusal contact (Fig. 15) [92,93]. The magnitude of the tooth movement is around 100 mm [94], which is 10-fold larger than the expected error level for a dental prosthesis.…”