Effect shapes of nanorods, nanowires and nanobelts TiO<sub>2</sub> on the degradation of MB photo catalyst.

Aziz, Wisam J.; Sabry, Raad S.; Jarallah, Abbas Kasoob

doi:10.1088/1742-6596/1032/1/012021

Cited by 3 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…After the finished product had been created, it was put in a glass autoclave, the autoclave was sealed and positioned in furnace at (120°C) for 3 hours, , After that, the white precipitate was centrifuged, and then D.W and ethanol were used to wash it many times in order to remove any remaining residue. Then annealing at (500ºC) for 3 hours [35].as shown in figure (1). Stainless steel mesh (SS mesh) was washed with acetone and ethanol in an ultrasonic bath for ten minutes and then rinsed with distilled water.…”

Section: Preparation Of Tio 2 Nanoparticles By Hydrothermal Methodsmentioning

confidence: 99%

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation

Majeed,

Sabry,

Abid

2024

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

Oil-contaminated water as a result of oil spill disasters or industrial disposal is a threat to human health and environmental sustainability on a global scale. The rising need for efficient oil-water separation has led to a growing interest in superhydrophobic materials for this purpose. Due to the regeneration ability of nanoparticles of titanium dioxide (TiO2), superhydrophobic and superolephilic TiO2/PDMS were created using a simple, low cost dip coating procedure. TiO2 (NPs) was synthesised by hydrothermal method and modified with PDMS (FS-1200 silicon sealant) solution. The mesh coated had remarkable superhydrophobicity, as seen by a contact angle of 155° with water. Additionally, the surface displayed superoleophilicity, as indicated by an oil contact angle (OCA) of 0°. The coated mesh surface was characterized by X-ray diffraction analysis, contact angle measurement, field emissions scanning electron microscopy (FE-SEM), Fourier transform infrared spectroscopy (FTIR), and energy dispersive spectroscopy (EDS). The separation of kerosene-water, diesel oil-water combinations, and sunflower oil-water may be effectively achieved via a simple filtering approach using a coated mesh. This method demonstrates a notable separation efficiency of 91.6%.

show abstract

Section: Preparation Of Tio 2 Nanoparticles By Hydrothermal Methodsmentioning

confidence: 99%

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation

Majeed,

Sabry,

Abid

2024

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

show abstract

Development of TiO2/polyvinyl alcohol-cellulose acetate nanocomposite reverse osmosis membrane for groundwater-surface water interfaces purification

Mansor

Abdallah

Shaban

2023

Materials Science and Engineering: B

View full text Add to dashboard Cite

Morphology-Dependent Photocatalytic Activity of Nanostructured Titanium Dioxide Coatings with Silver Nanoparticles

Shakeel,

Piwoński,

Kisielewska

et al. 2024

IJMS

View full text Add to dashboard Cite

This study aims to improve the photocatalytic properties of titanium dioxide nanorods (TNRs) and other related nanostructures (dense nanorods, needle-like nanorods, nanoballs, and nanoflowers) by modifying them with silver nanoparticles (AgNPs). This preparation is carried out using a two-step method: sol–gel dip-coating deposition combined with hydrothermal crystal growth. Further modification with AgNPs was achieved through the photoreduction of Ag+ ions under UV illumination. The investigation explores the impact of different growth factors on the morphological development of TiO2 nanostructures by modulating (i) the chemical composition, the water:acid ratio, (ii) the precursor concentration involved in the hydrothermal process, and (iii) the duration of the hydrothermal reaction. Morphological characteristics, including the length, diameter, and nanorod density of the nanostructures, were analyzed using scanning electron microscope (SEM). The chemical states were determined through use of the X-ray photoelectron spectroscopy (XPS) technique, while phase composition and crystalline structure analysis was performed using the Grazing Incidence X-ray Diffraction (GIXRD) method. The results indicate that various nanostructures (dense nanorods, needle-like nanorods, nanoballs, and nanoflowers) can be obtained by modifying these parameters. The photocatalytic efficiency of these nanostructures and Ag-coated nanostructures was assessed by measuring the degradation of the organic dye rhodamine B (RhB) under both ultraviolet (UV) irradiation and visible light. The results clearly show that UV light causes the RhB solution to lose its color, whereas under visible light RhB changes into rhodamine 110, indicating a successful photocatalytic transformation. The nanoball-like structures’ modification with the active metal silver (TNRs 4 Ag) exhibited high photocatalytic efficiency under both ultraviolet (UV) and visible light for different chemical composition parameters. The nanorod structure (TNRs 2 Ag) is more efficient under UV, but under visible-light photocatalyst, the TNRs 6 Ag (dense nanorods) sample is more effective.

show abstract

Effect shapes of nanorods, nanowires and nanobelts TiO₂ on the degradation of MB photo catalyst.

Cited by 3 publications

References 8 publications

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation

Development of TiO2/polyvinyl alcohol-cellulose acetate nanocomposite reverse osmosis membrane for groundwater-surface water interfaces purification

Morphology-Dependent Photocatalytic Activity of Nanostructured Titanium Dioxide Coatings with Silver Nanoparticles

Contact Info

Product

Resources

About

Effect shapes of nanorods, nanowires and nanobelts TiO2 on the degradation of MB photo catalyst.

Cited by 3 publications

References 8 publications

Fabrication of Superhydrophobic (TiO2/PDMS) Coating For Oil-Water Separation

Fabrication of Superhydrophobic (TiO2/PDMS) Coating For Oil-Water Separation

Development of TiO2/polyvinyl alcohol-cellulose acetate nanocomposite reverse osmosis membrane for groundwater-surface water interfaces purification

Morphology-Dependent Photocatalytic Activity of Nanostructured Titanium Dioxide Coatings with Silver Nanoparticles

Contact Info

Product

Resources

About

Effect shapes of nanorods, nanowires and nanobelts TiO₂ on the degradation of MB photo catalyst.

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation

Fabrication of Superhydrophobic (TiO₂/PDMS) Coating For Oil-Water Separation