Effect of Solids Loading on Slip‐Casting Performance of Silicon Carbide Slurries

Abstract

The influence of solids loading and particle shape on the green microstructure of slip‐cast bodies was investigated. Three commercial silicon carbide (SiC) powders (two coarse varieties with the same particle‐size distribution (PSD) but different particle shapes and a finer powder) were used to prepare bimodal PSDs designed to maximize the packing density. Various surface‐active agents (anionic, cationic, and non‐ionic) were tested. Anionic dispersants were the most effective in dispersing aqueous SiC slurries. The effectiveness of dispersants was evaluated by sedimentation tests using very dilute slurries, by rheology, and by the packing density of slip‐cast bodies prepared from suspensions loaded with 62.5 wt% solids, stabilized with a fixed amount of dispersant (0.25 wt%, relative to the solids). Then, the best dispersant was selected to study the effects of dispersant and solids concentrations on the degree of packing of bimodal suspensions that contained the sharper‐edged coarse particles. It could be observed that the green density was dependent on both parameters, initially showing an increase to a maximum, followed by a decreasing trend. A high value of 74.5% of the theoretical density (TD) was obtained from suspensions that contained 70 wt% solids and 0.1 wt% dispersant. The substitution of the angular coarse particles by similarly sized but more spherical particles resulted in an additional increase in green density to >76 wt% TD. The results can be interpreted in terms of freedom of particles upon deposition on the cast layer, which enables particle rearrangement, and segregation phenomena.

Temperature-induced gelation of concentrated silicon carbide suspensions

“…Besides traditional colloidal forming methods [7][8][9], some new nearnet-shape colloidal methods, such as gelcasting [10,11], direct coagulation casting (DCC) [12], have been introduced into the preparation of green SiC bodies.…”

Fabrication of yttria-stabilized-zirconia thick coatings via slurry process with pressure infiltration

“…where μ s is the viscosity of the solvent, φ m is the maximum particle packing fraction taken as 0.67 for soft-sphere systems, 25 and [η] is the intrinsic viscosity taken as 2.5 for spherical particles. Substituting μ from Eq.…”

Nanoparticle and poly(methyl methacrylate) co-dispersion in anisole

“…However, the major challenges for the casting process are the high solids loading necessary for the suspension, the capability to make \1 lm feature sizes, and the difficulties in avoiding cracks and feature breakage [4][5][6][7][8]. To overcome these difficulties, an alternative to casting is imprint lithography, which is especially suited for smaller size features [9].…”