Effect of slag viscosity model on transient simulations of wall slag flow in an entrained coal gasifier

Kim, Mukyeong; Ye, Insoo; Ryu, Changkook

doi:10.1007/s11814-018-0008-x

Cited by 6 publications

(1 citation statement)

References 26 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…With respect to the slag behavior, the most important property is the viscosity-temperature relation 15) , which is determined by a complicated interaction and transformation of the slag components. Further, the slag viscosity, which is very sensitive to temperature, increases logarithmically with decreasing temperatures 16) . When the slag reaches a particular temperature during cooling, certain slags begin to exhibit non-Newtonian fluid behavior and viscosity rises sharply because of crystallized mineral formation 17) .…”

Section: Introductionmentioning

confidence: 95%

Precipitation Behavior of Magnetite Phase during Modified Nickel Slag Treated by Molten Oxidation

et al. 2023

View full text Add to dashboard Cite

Nickel slag is a kind of solid waste with a high yield and low utilization rate.However, there is a large amount of Fe in nickel slag, which mainly exists in the form of fayalite.In this study, nickel slag is used as raw material. The addition of CaO can destroy the network structure of fayalite, and the iron-rich phase can be oxidized to magnetite under oxidation condition. It is beneficial to the recovery of iron resources. The effect of basicity on structural reconstruction of molten slag and precipitation of magnetite is investigated. The results show that when the basicity is 0.38~1.50, the degree of polymerization of silicate structure decreases with the increase of basicity. When the temperature is 1450~1500℃, viscosity of slag decreases first and then increases with the increase of basicity. The viscosity is the lowest with the basicity of 0.90, and the granular magnetite begins to precipitate during the non-equilibrium solidification at 1455℃. The growth rate of the magnetite is 1.20 μm/s at 0~10 s, which is significantly higher than the magnetite growth rate of 0.16 μm/s at 10~22 s, and the grain size of the magnetite remains unchanged after 22 s.

show abstract

Section: Introductionmentioning

confidence: 95%