Effect of Pore Evolution on Thermal Diffusivity and Radiation Characteristics of Thermal Barrier Coatings after High-Temperature Exposures

Abstract

Studying the impact of pores is crucial to enhancing the service performance of coatings, since they are a typical microstructure feature of thermal barrier coatings. In this paper, a coating prepared by the APS method was employed as the study object, and a scanning electron microscope and optical microscope were used to calculate the porosity after spraying or high-temperature exposures. Based on this, numerical calculations and simulations were used to evaluate the impacts of the pore structure and porosity on the heat conductivity and radiation characteristics of the coating. The results showed that, at high-temperature exposures, the horizontal pores inhibited thermal conductivity and radiation, but the column pores increased heat conductivity and radiation. The heat conductivity of the coating linearly decreased as the porosity increased, whereas the extinction coefficient increased, although at a slower and slower pace. When the porosity reached 15%, if the porosity was further increased, the thermal radiation energy did not change much, indicating that increasing the porosity would only block the heat radiation to a certain amount. This new and time-saving technique for materials research utilizing simulation and numerical computing may be utilized to optimize the microstructure of coatings to increase their service performance.

Terahertz Nondestructive Measurement of Heat Radiation Performance of Thermal Barrier Coatings Based on Hybrid Artificial Neural Network

“…On the one hand, it was the physical properties of the thermal barrier coating itself, and on the other hand, it was the time and temperature of the thermal barrier coating in service and the environmental parameters of the service. The change in micropores inside the thermal barrier coating had been elaborated on in the previous study [33]. For the phase change of the thermal barrier coating, the surface layer of the ceramic layer melted under hightemperature radiation, which caused it to change into a dense phase.…”

“…The radiation characteristics of thermal barrier coatings mainly included thermal conductivity and thermal radiation, and the radiation characteristics of thermal barrier coatings possessing different structural features have been numerically solved in a previous study [33], which elaborated the effects of different structural features on the thermal conductivity and thermal radiation characteristics. The solution models of thermal conductivity and radiation characteristics are shown in Equations ( 1)-( 4).…”