Effect of Microstructure on the Instantaneous Springback and Time-dependent Springback of DP600 Dual Phase Steel

Rong-ting, LI; Mai, Ruimin; Jin, Yongxi; Han, Ruiguo; Shu, Wang

doi:10.1088/1757-899x/389/1/012012

Cited by 1 publication

(1 citation statement)

References 17 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Its precision is affected and the development of such forming technology is restricted thereof. Nowadays, due to the amount of high-strength steel applications, the springback effect has been attracting increased attention [2,5,6,7].…”

Section: Introductionmentioning

confidence: 99%

Springback comparison between DP600 and DP800 steel grades

Almeida

Lima

Pereira

2020

Mater. Res. Express

View full text Add to dashboard Cite

A comparative study of the springback effect, otherwise known as elastic return, on Dual Phase DP600 and DP800 steel sheets is reported herein, which have been widely used in the automotive industry due to having good mechanical properties, such as high strength and ductility if compared to conventional steels. For such a purpose, it is proposed to analyze whether anisotropy and varying forming parameters interfere with the springback effect or not. The parameters selected to compare DP600 with DP800 dual phase steels were descending speed of 4 mm min −1 along the vertical axis of sheets until reaching internal bending angle of 30 degrees during bending tests at two rolling angles (0 and 90 degrees), thus forming a U-shaped steel sheet. In addition to bending tests, tensile tensting and Vickers microhardness tests have been performed at three rolling angles (0, 45 and 90 degrees). It was concluded that punching rate, internal bending angle, observation time and rolling angle exert an influence on the springback effect. Thereby, there is an important contribution to areas that require quality in formability, such as vehicle structure, which must have high impact strength and energy absorption. Steel sheets with increasingly smaller thicknesses are able to reduce density, product cost and greenhouse gases emissions from automobiles. MethodologyIn order to measure the springback effect, it was necessary to perform every metallography step and mechanical tests, such as bending, tension and Vickers microhardness testing. Metallography stepsThe metallography steps were performed in accordance with the ASTM E3-11 standard.

show abstract

Section: Introductionmentioning

confidence: 99%