Effect of mean void fraction correlations on a shell-and-tube evaporator dynamic model performance

Navarro-Esbrí, Joaquin; Milián, V.; Mota-Babiloni, Adrián; Molés, Franciscó; Verdú, G.

doi:10.1080/23744731.2015.1034594

Cited by 7 publications

(1 citation statement)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Setyawan et al, [14] reported a range of suction temperature from about 9 to 11C when the air conditioner was operated at outside air temperature from 32 to 38C. Discharge temperature of about 98C was reported by Esbrí et al, [15] from their experiment with R134a and IHX at condensing temperature of 40C and evaporating temperature of -4.7C. Using R153A, the discharge temperature was found at about 93C.…”

Section: Suction and Discharge Temperaturementioning

confidence: 92%

Evaluation of Air Conditioner Performance using Different Methods of Temperature Measurement

Setyawan

Badarudin²,

Arman³

et al. 2022

ARFMTS

View full text Add to dashboard Cite

Performance evaluation of an air conditioner using R410a has been evaluated by field measurement of pressure and temperature at suction and discharge line. Two methods were used for temperature measurement. First, the sensors were mounted on the outer wall of pipe and second, the sensors were inserted into the refrigerant flow in the pipe. Using the second method, the suction temperature is averagely 5.0°C lower and the discharge temperature is 17.8°C higher than that of the first method. The coefficient of performance and power consumption resulted from the second method is in a good agreement with that of standardized test according to ISO 5151:2017. This indicates that the temperature sensor insertion to the refrigerant flow gives the better accuracy in the evaluation of performance of an air conditioner.

show abstract

Section: Suction and Discharge Temperaturementioning

confidence: 92%

Evaluation of Air Conditioner Performance using Different Methods of Temperature Measurement

Setyawan

Badarudin²,

Arman³

et al. 2022

ARFMTS

View full text Add to dashboard Cite

show abstract

Modeling and experimental analysis of the solar radiation in a CO2 direct-expansion solar-assisted heat pump

Paulino

Oliveira

Maia

et al. 2019

Applied Thermal Engineering

View full text Add to dashboard Cite

Dynamic modeling of a centrifugal chiller with hybrid falling film evaporator including pressure drop computation

Foliaco,

Bula,

Jaramillo

et al. 2024

Applied Thermal Engineering

View full text Add to dashboard Cite

Effect of mean void fraction correlations on a shell-and-tube evaporator dynamic model performance

Abstract: In this paper, the influence of different mean void fraction correlations on a shell-and-tube

Cited by 7 publications

References 19 publications

Evaluation of Air Conditioner Performance using Different Methods of Temperature Measurement

Evaluation of Air Conditioner Performance using Different Methods of Temperature Measurement

Modeling and experimental analysis of the solar radiation in a CO2 direct-expansion solar-assisted heat pump

Dynamic modeling of a centrifugal chiller with hybrid falling film evaporator including pressure drop computation

Contact Info

Product

Resources

About