Effect of ITO Surface Treatment on Organic Solar Cells

Seol, Jiyoun; Monroe, Matthew Lowell; Anderson, Timothy J.; Hasnain, Md Saquib; Park, Chinho

doi:10.1109/wcpec.2006.279433

Cited by 6 publications

(12 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Regarding the contact angle, the results of samples A, B, C with angles 66.9, 65.8, 67.9 respectively are very similar. These values are in agreement to the contact angle of commercial 6 ITO [27,28], and are dissimilar to the contact angle of sample D, 87.3. The explanation for this difference is that samples A, B and C are thermally treated, which causes changes in the morphology of a metal oxide thin-film [29], and sample D is not thermally treated.…”

Section: Characterization Of Ito Thin-filmssupporting

confidence: 54%

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Villar

Zamarreño

Hernáez

et al. 2015

Optics & Laser Technology

View full text Add to dashboard Cite

Silicon wafers coated with Indium Tin Oxide (ITO) by application of sputtering technique have been characterized after different post-annealing techniques, showing that this last factor is critical for the quality of the thin-film and for the creation and tuning of both surface plasmon resonances and lossy mode resonances. By adequate selection of the ITO thin-film thickness both resonances can be tracked in the same spectrum, which can be used in sensor and optical communications fields.

show abstract

Section: Characterization Of Ito Thin-filmssupporting

confidence: 54%

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Villar

Zamarreño

Hernáez

et al. 2015

Optics & Laser Technology

View full text Add to dashboard Cite

show abstract

“…Fullerenes have long been considered as promising building blocks for optoelectronic devices, benefited from their unique physical, chemical, and mechanical properties. , However, the introduction of fullerenes onto the 2D-nanosheet surface of MoS 2 to produce C 60 –MoS 2 hybrid nanocomposites was rarely reported, despite their interesting properties suggested by simulation studies . The recent attempt on the experimental preparation of C 60 –MoS 2 nanocomposite was performed by Remškar et al in 2005 using a catalyzed transport reaction typically run at 1030 K under a pressure of 10 –3 Pa for 22 days .…”

Section: Introductionmentioning

confidence: 99%

Templating C₆₀ on MoS₂ Nanosheets for 2D Hybrid van der Waals p–n Nanoheterojunctions

Chen

Lin

et al. 2016

Chem. Mater.

View full text Add to dashboard Cite

C 60 and single-layer MoS 2 nanocomposites were facilely prepared via a combined solvent transfer and surface deposition (STSD) method by templating C 60 aggregates on 2D MoS 2 nanosheets to construct hybrid van der Waals heterojunctions. The electronic property of the hybrid nanomaterials was investigated in a direct charge transport diode device configuration of ITO/C 60 −MoS 2 nanocomposites/Al; rewritable nonvolatile resistive switching with low SET/RESET voltage (∼3 V), high ON/OFF resistance ratio (∼4 × 10 3 ), and superior electrical bistability (>10 4 s) of a flash memory behavior was observed. This particular electrical property of C 60 −MoS 2 nanocomposites, not possessed by either C 60 or MoS 2 nanosheets, was supposed to be due to the efficiently established C 60 /MoS 2 p−n nanojunction, which controls the electron tunneling via junction barriers modulated by electric-field-induced polarization. Thus, our 2D templating method through STSD is promising to massively allocate van der Waals p−n heterojunctions in 2D nanocomposites, opening a window for important insights into the charge transport across the interface of organic/2D-semiconductors.

show abstract

“…[ 116 ] Moreover, the chemical interaction of oxygen‐based plasma systems can form strong carbon–oxygen (C–O) covalent bonds of higher polarity than those of carbon–hydrogen (C–H) bonds. [ 112,114,117 ]…”

Section: Lt‐sno2 Modification Methodsmentioning

confidence: 99%

“…[116] Moreover, the chemical interaction of oxygen-based plasma systems can form strong carbonoxygen (C-O) covalent bonds of higher polarity than those of carbon-hydrogen (C-H) bonds. [112,114,117] In recent times, plasma utilization has been acknowledged to be an efficient posttreatment procedure. In particular, the impacts of plasma treatment on metal oxide-based semiconductors to control carrier concentrations associated with oxygen vacancies have enormously attracted research interests.…”

Section: Plasma Treatmentmentioning

confidence: 99%

Low‐Temperature Processing Methods for Tin Oxide as Electron Transporting Layer in Scalable Perovskite Solar Cells

et al. 2023

View full text Add to dashboard Cite

Perovskite solar cell (PSC) technology experiences a remarkably rapid growth toward commercialization with certified efficiency of over 25%, along with the outstanding breakthrough in the development of SnO2. Owing to the wide bandgap, high electron mobility, chemical stability, and low photocatalytic activity, SnO2 has been the rising star to serve as electron transporting layer (ETL). More importantly, the low‐temperature fabrication process (<200 °C) enables SnO2 a promising candidate for the industry, making it compatible with the plastic substrates and large‐scale production, which is crucial for the flexible and scalable devices fabrication. In this review, the processing methods (solution‐based, vacuum‐based, and vapor‐based deposition) of low‐temperature SnO2 (LT‐SnO2) and the pros and cons of them with a focus on their scalability are discussed. Additionally, the morphologies of obtained LT‐SnO2 are investigated to guide the design and performance improvement of devices. The modification strategies to reduce undesired nonradiative recombination and passivate the defects in the bulk or at the interface of LT‐SnO2, influencing the quality of perovskite films, together with the efficiency and stability of cells are summarized. This review is a comprehensive overview of the studies on low‐temperature SnO2 ETL and provides detailed instructions for scalable PSCs.

show abstract

Effect of ITO Surface Treatment on Organic Solar Cells

Cited by 6 publications

References 4 publications

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Templating C₆₀ on MoS₂ Nanosheets for 2D Hybrid van der Waals p–n Nanoheterojunctions

Low‐Temperature Processing Methods for Tin Oxide as Electron Transporting Layer in Scalable Perovskite Solar Cells

Contact Info

Product

Resources

About

Effect of ITO Surface Treatment on Organic Solar Cells

Cited by 6 publications

References 4 publications

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Generation of Surface Plasmon Resonance and Lossy Mode Resonance by thermal treatment of ITO thin-films

Templating C60 on MoS2 Nanosheets for 2D Hybrid van der Waals p–n Nanoheterojunctions

Low‐Temperature Processing Methods for Tin Oxide as Electron Transporting Layer in Scalable Perovskite Solar Cells

Contact Info

Product

Resources

About

Templating C₆₀ on MoS₂ Nanosheets for 2D Hybrid van der Waals p–n Nanoheterojunctions