Effect of interfiber bonding on the rupture of electrospun fibrous mats

Abstract

Electrospun fibrous mats have a wide range of applications, and characterizing their mechanical behavior is an important task. In addition to the mechanical properties of the individual fibers, other factors can alter the overall mechanical behavior of the mat. In this study, we use computational and experimental methods to investigate the effect of interfiber bonding on the failure and rupture of typical fibrous mats. A non-linear finite element model of a mat is simulated with randomly distributed fibers with different porosities. The percentage of bonding between intersecting fibers is controlled by an auxiliary code. The results reveal that interfiber bonding increases the stiffness of the mat, and the toughness of the mat increases as well. Interestingly, a large percentage of interfiber bonding at a predefined porosity of a mat does not increase the elastic modulus of the mat, nor does it have considerable effects on the failure behavior. Moreover, the effect of interfiber bonding increases with a mat’s porosity. The findings of this study could help tune the mechanical properties of fibrous mats used for different applications.

Enhancement of electrospun UHMWPE fiber performance through post‐processing treatment

“…45 It shows that fiber strength is typically determined by the strength of the lateral bond between the molecules. A similar observation is also reported by Chavoshnehad et al 46 and Negi et al 47 on the failure mode of electrospun non-woven fiber mat during tensile loading on account of slippage or displacement of fibers between welded (fused) and unbonded fibers. It was suggested that, compared to the van der Waals interaction between nearby chains, the covalent connections along the polymer molecular chains support better energy transmission.…”

Improved Biocompatible, Flexible Mesh Composites for Implant Applications via Hydroxyapatite Coating with Potential for 3-Dimensional Extracellular Matrix Network and Bone Regeneration

“…It is expected the latter can promote solution’s movement from one side to the other side of the substrate during coating, which leads to more contact between solution and wire’s surface, resulting in more uniform coverage. The topography of the coating surface for mesh size 200 (smaller wire diameter) is smoother than mesh size 100 due to the overall flatter pattern: reduced wire bending at the junctions and smaller distance between wire peaks and valleys. , …”

“…The topography of the coating surface for mesh size 200 (smaller wire diameter) is smoother than mesh size 100 due to the overall flatter pattern: reduced wire bending at the junctions and smaller distance between wire peaks and valleys. 39,40 3.2.3. Coating Thickness.…”

Mechanical properties of an epoxy-based coating reinforced with silica aerogel and ammonium polyphosphate additives

“…In recent decades, employing polymers in various applications such as protective coatings, aerospace industry, filtration, biomembrane has increased dramatically. [1][2][3] Among different polymers, excellent properties of epoxy resins, like good mechanical and adhesion performance, dielectric properties, and high corrosion resistance, have made them ideal for the protective coatings' matrix. However, together with the broad advantages of epoxy materials, high flammability, poor thermal stability, and low impact strength have restricted their applications as coatings.…”