2011
DOI: 10.1016/j.physb.2010.12.017
|View full text |Cite
|
Sign up to set email alerts
|

Effect of granularity and inhomogeneity in excess conductivity of YBa2Cu3O7−δ+xBaTiO3 superconductor

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1

Citation Types

0
4
0

Year Published

2012
2012
2024
2024

Publication Types

Select...
8

Relationship

0
8

Authors

Journals

citations
Cited by 13 publications
(4 citation statements)
references
References 33 publications
0
4
0
Order By: Relevance
“…It is important for the analysis of the experimental data to have a precise determination of the Т с [22,23]. In our case T c is defined by the maximum on dρ ab (T)/dT dependencies in the superconducting transition region ( Fig.…”
Section: Resultsmentioning
confidence: 99%
“…It is important for the analysis of the experimental data to have a precise determination of the Т с [22,23]. In our case T c is defined by the maximum on dρ ab (T)/dT dependencies in the superconducting transition region ( Fig.…”
Section: Resultsmentioning
confidence: 99%
“…This may be due to the sticking of nanosized CoFe 2 O 4 on the surface of the grains, leading to increase in grain connectivity and filling up of cracks and voids. Mohanta et al [24] Table 1. It is clear that the grain size shows a decrement behavior from 1.52 to 0.98 μm as x increases from 0 to 0.1, which suggests that nanosized CoFe 2 O 4 acts as a well growth inhibitor which limits the grain size [25].…”
Section: Resultsmentioning
confidence: 99%
“…Stiochiometric amount of high-purity powders of Y 2 O 3 , BaCO 3 and CuO precursors were grinded and calcined at 870°C. BTO precursor powder was synthesized through chemical route method calcined at 1250°C for 2 h. Zeta particle analyser revealed that the average particles size of BTO calcined powder ranged between 100-400 nm [21]. A series of polycrystalline composite samples of (1 À x) YBCOþx BTO (x ¼0.0, 1.0, 2.5, 5.0 and 10.0 wt%) were then pressed into pellets for final sintering at 920°C for 12 h. The process was followed by oxygen annealing at 500°C for 12 h to obtain well oxygenated densely packed samples.…”
Section: Methodsmentioning
confidence: 99%