Effect of Ferric Oxide and Magnesium Oxide Nanoparticles on Iraqi Bentonite Performance in Water Based Drilling Fluid

Abstract

In oil and gas industry, the nanotechnology has been applied in different fields. Reservoir, exploration, drilling, completion, production, processing, and refinery are nanotechnology applications fields. Nanoparticles materials are one of the areas that are utilized in preparing drilling fluids. These nanomaterials are used to formulate high performance drilling fluids. In other words, these nano particles materials can be used to design smart drilling fluids. The properties of these drilling fluids can be met the well conditions requirements. The aim of this study is to enhance the performance of Iraqi bentonite in drilling fluids using nanomaterials. Iraqi calcium montmorillonite clay (Ca- bentonite) from Wadi Bashera in Iraqi Western Desert was obtained and studied in order to use it as an alternative active solid to the imported commercial bentonite. Water based drilling fluids were prepared with 3, 6, and 12 wt. % of Iraqi bentonite. Mgnesium oxide nanoparticles (MgO NPs) and ferric oxide nanoparticles (Fe2O3 NPs) with different concentrations were used. The experimental work showed that, MgO NPs resulted in a significant increase in the rheological properties of drilling fluids prepared with 3 and 6 wt. % of Iraqi bentonite. In contrast, moderate effect on the rheological properties of drilling fluid prepared with 12 wt. % of Iraqi bentonite were obtained with low concentrations of Fe2O3 NPs. Basically drilling fluids prepared with Iraqi bentonite had extreme filtrate volume compared with API specifications and poor controlling to filtration properties were obtained with MgO NPs and Fe2O3 NPs additions. The impact of these two nanomaterials was revealed on the stability of drilling fluids prepared with Iraqi bentonite, where an enhancemment from 65 % to 100% was observed.

A Comprehensive Review of Nanotechnology Applications in Oil and Gas Well Drilling Operations

“…In order to gain access to these reservoirs, geothermal exploration and drilling initiatives have significantly increased during the past few decades [146][147][148]. Geothermal energy is produced by drilling wells into these reservoirs and using circulating fluids that are either injected into or taken from the geothermal reservoirs to capture the heat of the Earth [149]. Notably, drilling methods used in oil and geothermal wells are comparable [150].…”