Effect of coconut oil-blended fuels on diesel engine wear and lubrication

Abstract

This paper presents the results of an experimental investigation into the wear and lubrication characteristics of a diesel engine using ordinary coconut oil (COIL)‐blended fuels. The blended fuels consisted of 10, 20, 30, 40, and 50% COIL with diesel fuel (DF2). Pure DF2 was used for comparison purposes. The engine was operated with 50% throttle setting at a constant speed of 2000 rpm for a period of 100 h with each fuel. The same lubricating oil, equivalent to SAE 40, was used for all fuel systems. A multi‐element oil analyser was used to measure wear metals (Fe, Cr, Cu, Al, and Pb), contaminant elements (Si, B, and V), and additive elements (Zn, Ca, P, and Mg) in the used lubricating oil. Fourier transform infrared analysis was performed to measure the degradation products (soot, oxidation, nitration, and sulphation products) in the used lubricant. Karl Fischer (ASTM D 1744) and potentiometric titrations (ASTM D 2896) were used to measure water concentration and total base number (TBN), respectively. An automatic viscometer (ASTM D 445) was used to measure lubricant viscosity. The results show that wear metals and contaminant elements increase with an increasing amount of COIL in DF2. An increasing amount of COIL in the blends reduces additive elements, with the reduction for blends of up to 30% COIL being quite similar to that for DF2. Soot and sulphation decrease with increasing COIL in the blended fuels due to reduced aromatics and sulphur in comparison to DF2. The water concentration increases for blended fuels with more than 30% COIL. The TBN and viscosity changes are found to be almost normal. The engine did not appear to have any starting and combustion problems when operating with the COIL‐blended fuels. The lubricating oil analysis data from this study will help in the selection of tribological components and compatible lubricating oils for coconut oil‐ or biofuel‐operated diesel engines.