Durability under thermal loads of polyvinyl alcohol fibers

Abstract

In the present paper, the thermal durability of polyvinyl alcohol fibers (PVA) was studied after fiber samples had been subjected to temperatures ranging from 90°C to 250°C. Residual mechanical properties, such as tensile strength, elastic modulus and elongation at break, and physical properties, such as density were determined. Weibull statistics were used to quantify the degree of variability in fiber strength, at the different temperature. In addition, thermal analysis of PVA fibers were carried out employing thermogravimetry and differential scanning calorimetry up to the temperature of 800°C. SEM analysis of heated and unheated samples had been carried out in order to allow the identification of the changes in the microstructure of the fibers. The degradation process of PVA fibers manifests itself in a significant loss of mass, stiffness and strength of the fibers, which is progressive with increasing temperature. Thermal analysis has shown that the melting point of PVA fibers begins at approximately 200°C and thermal degradation initiates at about 239ºC. However, progressive loss in tensile strength and elastic modulus was observed starting at a temperature as low as 90°C, due to glass transition temperature of PVA fibers at approximately 66°C. At 220°C, the elastic modulus and strength were reduced at about 45% and 52%, respectively, when compared with respective values of unheated samples. With regards to Weibull modulus, the statistical parameter did not exhibit significant influence on temperature for samples heated up to 145°C, which ranged from 23.4 to 28.8. However, samples heated to 220°C showed a sudden reduction in Weibull modulus to 8.6, indicating that a significant change occurred in the populations of fracture inducing flaws at this temperature level, which clearly affect the tensile strength and Weibull modulus.

Comparison of engineered cementitious composites and concrete for strengthening of concrete structural details using RBSM

“…The trend of the stress-strain curve of the bond is similar to the stress-strain curve of the PVA fibers in tension [11], which means that the bond is provided mostly by the PVA fibers. The tensile bond behavior was presented in previous numerical and experimental study [5], where the tensile stress-strain relation is expressed by a cubic parabola up to the failure without any softening brunch (Figure 5a)), where Δu is the relative normal displacement of the spring and Δutu is its ultimate relative normal displacement.…”

Fabricación de filamentos de PCL y PVA reforzados con HAp para ser usados en impresión 3D

“…Sin embargo, un factor crítico que debió tomarse en cuenta fue que la temperatura de degradación se encontró muy cercana a la de fusión. Este resultado, sumado a resultados reportados anteriores [15] hizo pensar que la cercanía de la temperatura de fusión y la de degradación podría tener implicaciones durante el proceso de extrusión y consecuentemente en las propiedades finales de este material. En otras palabras, el proceso de extrusión se debe realizar manteniendo una estabilidad térmica que no exceda un ±5°C de la temperatura seleccionada, con el fin de mantener el PVA en estado fundido y no en degradación.…”

Thermal stability of PVA fiber strain hardening cement-based composites

“…The fibers used in this study were PVA fibers (trademark REC15), manufactured by Kuraray Co -Japan, with a diameter of 40 lm, density of 1.31 g/cm 3 , elastic modulus of 39.93 ± 1.90 GPa, tensile strength of 1576.20 ± 60.90 MPa [17]. According to thermal analysis reported in Fig.…”

“…In addition, the onset degradation temperature of PVA fiber is about 239°C (see Fig 2(a)). More information about the thermal durability of polyvinyl alcohol fibers can be found in [17].…”