Drying of poloxamer hydrogel films

Abstract

The drying of hydrogel films formed by Poloxamer 407 poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) amphiphilic block copolymer was investigated at various air relative humidity (RH) conditions ranging from 11 to 97%. Initially, the amount of water lost increased linearly with the drying time. After this linear region (stage I), a nonlinear behavior was observed (stage II). The drying rate increased with decreasing RH, thus greatly shortening the drying time. A decrease of the film thickness also shortened the drying time; however, the drying mechanism did not change. Three models for one-dimensional water diffusion were used to fit the experimental results at different RH conditions and film thicknesses. Model 1 assumes semi-infinite medium and constant diffusion coefficient, and fits very well the data in stage I of the drying process. The fitted water diffusion coefficient (D) is 5 Â 10 À10 m 2 /s, whereas the effects of the RH are captured by a proportionality constant (a) that appears in the boundary condition. Model 2 considers a finite (constant) film thickness and captures the experimental observations over the whole drying period for the same D and a as in Model 1. The analytical solutions available for Models 1 and 2, used together with the experimentally derived model parameters D and a, allow for easy estimation of drying time and water loss from Poloxamer hydrogel films of various compositions and thicknesses and at different relative humidities. Numerical solutions for water diffusion under conditions of decreasing film thickness and diffusion coefficient being a function of concentration are also presented (Model 3). It becomes apparent from the fit of the data to the different models that the drying rate is more sensitive to the boundary condition at the film-air interface (represented by a) than to the diffusion in the film. It is notable that the a values obtained from the fits of the Poloxamer hydrogel drying rate are comparable to those obtained from drying of water films under the same experimental conditions. ß

Drying colloidal systems: Laboratory models for a wide range of applications

“…The drying always starts with a phase with quasi-constant evaporation rate (CR). This type of behavior is also encountered in the drying of hydrogels, fruits and food [35,56,60,61]. This first phase usually lasts about five minutes under the drying conditions that we have implemented (room temperature and relative humidity close to 43%).…”

Amphiphilic polysilane with poly(ethylene oxide) side chains

“…The percentage of water loss in AT‐PEO is larger than that of water gain after the same amount of time, which means that water desorption is faster than water sorption for this polymer. The percentage of water loss is initially linear, indicating that water desorption is an evaporation‐limited process 39. In the case of water desorption, the initial water content is 45 wt %.…”

Investigation of water diffusion dynamics in corneal phantoms using terahertz time-domain spectroscopy

“…its thickness [21]. Hence, we implemented a hydrogel diffusion model that calculates the thickness and water content profiles using initial parameters from the manufacturer, initial geometry and gravimetric measurements to determine water loss [19]. The flowchart in Fig.…”

“…Previous THz dehydration studies relied on either overall hydration measurements or literature values for in vivo hydration profiles with constant sample thickness to simulate the THz response of the sample [5,7,9,18]. We created a diffusion model, based on Gu et al [19], to predict a thickness and hydration profile at each measured time point in the drying process. The predicted hydration profiles were then input in a stratified composite-media model to simulate THz-TDS measurements.…”