Driven dart impact response and simulation of a multi-layer HDPE

Xiao, Xinran; Virupaksha, Vinayshankar L.

doi:10.1080/13588260902837270

Cited by 3 publications

(1 citation statement)

References 14 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Referring to [14,15], carbon foams show an evident strain rate effect like some metallic and polymer foams [1,7,10,16,18,19,21,24], which has been well described by a micro-mechanical model typical of ceramic materials. These materials, despite their brittle nature, exhibit an evident compression strength dependency by the strain rate due to small cracks dynamic growth.…”

Section: Strain Rate Materials Response Dependencymentioning

confidence: 97%

Numerical investigation on carbon foam-based dampers for helicopter seats

Cacchione

Janszen

Nettuno

2011

International Journal of Crashworthiness

View full text Add to dashboard Cite

From the beginning of the early 1960s helicopter seats underwent a deep evolution. They play a key role in survivability during emergency landings. The rotorcraft structure must be, in fact, designed to give to each occupant every reasonable chance of avoiding severe injury in crash landings. To reach this result several improvements in the design of crashworthy seats with special emphasis on the energy absorption systems were introduced during development of rotorcrafts. This paper, based on previous experiments on carbon foam modelling under high strain rate evolution, will show their potential application for an energy absorption system based on a constant load response. This solution would allow easy manufacturing, lightweight structures, as well as possible further development into variable load energy absorbers. These latter represent a further evolution providing better performances for occupants of different weights beyond certification requirements. The investigation has been developed in two phases: first a typical engineering test was computed on carbon foam-based damper finite element model; second, this was followed by an hybrid FEM multi-body modelling of seats certification procedure using previous results as lumped element. Finally, a comparison with the state of the art constant load energy absorption system was performed. The carbon foam-based system showed good performance compared with an ideal fixed load energy absorber (FLEA). The results demonstrated that this kind of material could offer a new solution to limit the load transmitted to the occupants of a helicopter seat during emergency landing and suggested to investigate for further development and experimental testing.

show abstract