Dispersion of Carbon-Nanotubes in a Polymer Matrix by a Twin-Screw Extruder II

Takase, Hirofumi; Furukawa, Masaki; Kishi, Hajime; Murakami, Atsushi

doi:10.4325/seikeikakou.17.50

Cited by 7 publications

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Polystyrene (PS), Polycarbonate (PC), Polymethyl methacrylate (PMMA). Takase et al [18,19] Traditional polymer processing of twin screw extrusion has been widely used in melt compounding process, which provided uniform fiber dispersion by the large shear forces during processing [23].…”

Section: Introductionmentioning

confidence: 99%

Properties of Poly (Carbonate)/Vapor-Grown Carbon Fiber Composite Prepared by Melt compounding

et al. 2011

View full text Add to dashboard Cite

We discussed the effect of Polycarbonate (PC) type and Vapor-Grown Carbon Fiber (VGCF) size on the mechanical properties of PC/VGCF composites prepared by melt compounding using a twin screw extruder. Four kinds of PC which have different melt volume flow rate, and two kinds of VGCF which have different aspect ratio (VGCF-S which is the aspect ratio of 100, and VGCF-H which is the aspect ratio of 40.) were used in this study. In addition, the several VGCF contents were set up in each PC/VGCF composite. The Young's modulus of PC/VGCF composite overall increases with VGCF content in each case. However, the enhancement of Young's modulus in PC with low and high melt viscosity is little. Tensile strength, which is maximum stress during tensile testing, of PC/VGCF composite increases a little with VGCF content except for the case using PC with high melt viscosity. Though VGCF-S is the smaller surface area and higher aspect ratio as compared with VGCF-H, the effect of each VGCF on the mechanical properties of PC is almost same. The dispersion, aggromeration and breaking of VGCF could be interpreted from the investigation of the morphology, thermal properties and Halpin-Tsai model, which predicts the Young's modulus of the polymer/fiber composites. We concluded that the VGCF could be easily broken in high viscosity matrix.

show abstract

Section: Introductionmentioning

confidence: 99%