Direct‐Patterning SWCNTs Using Dip Pen Nanolithography for SWCNT/Silicon Solar Cells

Abstract

Dip pen nanolithography (DPN) is used to pattern single-walled carbon nanotube (SWCNT) lines between the n-type Si and SWCNT film in SWCNT/Si solar cells. The SWCNT ink composition, loading, and DPN pretreatment are optimized to improve patterning. This improved DPN technique is then used to successfully pattern >1 mm long SWCNT lines consistently. This is a 20-fold increase in the previously reported direct-patterning of SWCNT lines using the DPN technique, and demonstrates the scalability of the technique to pattern larger areas. The degree of the uniformity of SWCNTs in these lines is further characterized by Raman spectroscopy and scanning electron microscopy. The patterned SWCNT lines are used as thin conductive pathways in SWCNT/Si solar cells, similar to front contact electrodes. The critical parameters of these solar cells are measured and compared to control cells without SWCNT lines. The addition of SWCNT lines increases power conversion efficiency by 40% (relative). Importantly, the SWCNT lines reduce average series resistance by 44%, and consequently increase average fill factor by 24%.

The Use of Gravity Filtration of Carbon Nanotubes from Suspension to Produce Films with Low Roughness for Carbon Nanotube/Silicon Heterojunction Solar Device Application

“…CNT suspensions were prepared using previously published approaches [37][38][39]. A surfactant solution was formed by adding Triton X-100 to water at a concentration of 1% v/v.…”

Exploiting rotational asymmetry for sub-50 nm mechanical nanocalligraphy

“…Continued progress in nanotechnology however, relies on our ability to effectively define structures with 1-100 nm precision on a variety of materials [4][5][6] ; a task which becomes increasingly challenging as device dimensions shrink and the range of materials expands. To achieve this increasingly onerous task, a wide spectrum of top-down and bottom-up approaches have been deployed with emphasis on resolution, cost, and throughput-depending on the application-and ranging from complementary metal-oxide-semiconductor (CMOS) processes for nanoelectronics 7,8 to the additive patterning of biological 9,10 and 2D materials [11][12][13][14] . Among these methods, the family of scanning probe lithographies (SPLs) have attracted significant attention due to their unmatched flexibility in materials processing, maskless operation, and the ultra high resolution they afford 5 .…”

Graphene‐Based Materials in Planar Perovskite Solar Cells

“…With a power conversion efficiency (PCE) exceeding 20%, crystalline silicon (polysilicon or monocrystalline silicon) solar cells are currently dominating the photovoltaic (PV) market. [ 18,19 ] Nonetheless, the further development of silicon solar cells is limited because of the complex production process, high production cost, and the PCE that is already close to the theoretical limit value. The silicon wafer is brittle which restricts its application in flexible solar cells.…”