Digital predistortion with low-precision ADCs

Tarver, Chance; Cavallaro, Joseph R.

doi:10.1109/acssc.2017.8335381

Cited by 2 publications

(2 citation statements)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A full-band DPD is the one in which the entire LTE signal needs to be passed through the feedback path to be linearized. So, in this the entire transmit band near the main carriers is linearized [5]. It is responsible for the reduction of the spurious emissions i.e.…”

Section: Simulation Of Full-band Dpdmentioning

confidence: 99%

“…In this, we use an RF down-converter which can be tuned to the specific desired frequency of a violating spurious emission or intermodulation products like IMD3, IMD5 etc. It is followed by an analog low-pass filter (LPF) which is used for anti-aliasing and attenuation of the higher-power main carriers [5]. It makes its dynamic range high and due to which, this available range can be efficiently used with a low-precision ADC for receiving the desired spurious emission.…”

Section: Fig 4 Simulation Of Sub-band Dpdmentioning

confidence: 99%

See 1 more Smart Citation

Performance Evaluation of Digital Pre-Distortion Technique using Low-Complexity and Low-Precision ADC

Kaur*¹,

Kaur²,

Singh³

2019

IJITEE

View full text Add to dashboard Cite

This paper analyzes the Digital Pre-Distortion linearization technique using a low-precision Analog-to-Digital Converter (ADC). The output of a power amplifier exhibits various spurious emissions, spectral regrowth and intermodulation distortion (IMD) products due to its non-linear behavior. So, to preserve the performance of power amplifier, linearization becomes mandatory. Digital Pre-Distortion does the training on the output of the power amplifier (distorted signal) and generates exactly the inverse characteristics to that of power amplifier. Their cascading results into a linear response. In practical systems, the output of power amplifier has to go through an analog-to-digital converter for digital processing and a low-resolution ADC results in the degradation of the signal and affects the DPD performance. But a low-resolution ADC not only reduces the computational complexity in the digital processing but it also provides lower power consumption and costs less because less hardware would be required. In this work, the aim is to find the precision up to which ADC resolution can be reduced without affecting the DPD performance in a significant manner. This paper evaluates the performance of two DPD systems - Full-band DPD and Sub-band DPD and from simulations, it is observed that for a full-band DPD, 1-bit ADC can be reliably used and for a sub-band DPD, single bit to 4-bits ADC can be used.

show abstract

Section: Simulation Of Full-band Dpdmentioning

confidence: 99%

Section: Fig 4 Simulation Of Sub-band Dpdmentioning

confidence: 99%