Development of TRIP phenomenon using power refining of retained austenite by niobium

Abstract

The illustrations above demonstrate that as the percentage of niobium increases, the grain size decreases, leading to an increase in the stability of transformation induced plasticity steel. This, in turn, results in improved mechanical strength. The optimal volume fraction of retained austenite for a significant transformation induced plasticity effect to occur is reported to be in the range of 10 vol. %–20 vol. %. The volume fraction of retained austenite directly determines the carbon content and grain size of the retained austenite, its two main stabilization factors. The stability of the retained austenite dictates when the strain‐induced martensite transformation (SIMT) occurs during straining of transformation induced plasticity high strength steel. Unstable retained austenite transforms almost immediately upon deformation, increasing work hardening rate and formability during the stamping process. At the appropriate stability of the retained austenite, the Strain‐Induced Martensite Transformation begins only at strain levels beyond those produced during stamping and forming, and the retained austenite is still present in the final part; it can transform into martensite in the event of a crash, providing greater crash energy absorption. The tensile strength level of micro‐alloyed transformation induced plasticity steels may exceed 1 GPa. Grain refinement mechanism is considered as the most applied mechanism used in increasing of steel strength without deterioration of ductility and toughness. Recently, it was proposed that the grain refinement could act positively on promoting the transformation induced plasticity effect of advanced high strength steel through improving the stability of retained austenite. In this research, quenching and partitioning heat treatment technique was applied to four grades of low carbon steel with different percentage of niobium. Then, the effect of niobium on grain refinement has been detected by microstructure observations. Mechanical properties and strain hardening properties of investigated steel have been determined. In addition, by using x‐ray diffraction, as well as a new electric resistance‐based sensor, it was possible to characterize the stability of the retained austenite through the plastic deformation of steel. Grain refinement by using of niobium has a great impact on promoting the stability of retained austenite against the plastic stress at the plastic deformation zone.